User's Manual

Vehicular Repeater System
Futurecom Systems Group ULC. 8A083X22 Rev 4_2E.docxDOC Rev. Preliminary Page 13
APPENDIX 1
General Specifications
Dimensions Height / Width / Depth 92mm (3.63”) / 186mm (7.32”) / 315mm ( 12.41”)
Weight 5.2 kg (11.5 lbs) approx.
Channel Spacing 12.5 kHz or 25 kHz
Analog Voice or P25 Modulation
Power Supply
13.8 VDC  20%, negative ground only
DC Current Drain Repeater OFF
RPTR Standby
Receive
Transmit
Max. 0.01 A
Max. 0.8 A
Max 1.7 A @ 7.5 W Audio @ 13.8 VDC
Max. 6.0 A @ 20 W RF output at TX Connector
Operating Temperature -30°C to +60°C
Protection Against Liquids IP6 (water jet proof)
RF Connector Impedance 50 Ohm
Duty Cycle
VHF, UHF
700MHz, 800MHz
50% TX – 50% RX
100% TX
External Connectors
RF Connectors
Computer Interface
Mobile Radio
DC Power
TNC female
USB, 9 pin male circular (programming only)
20 pin male circular:
RS232: 115 kbps max., +/-3V min. input, 5 kOhm
input impedance, 300 Ohm output impedance
Analogue audio ports: 200 kOhm input impedance,
15 Ohm output impedance
6 pin male circular
Power Output at TX Connector
Standalone Mode:
FCC Simultaneous DVRS Repeated
and Mobile Operation:
20 W Max. (programmable per channel from 1 W Min.)
5W, 6W, 10W or 20W Max. (programmable per channel
from 1 W Min.)
Refer to RF Safety Booklet for maximum allowed power
output for specific approved DVRS, Mobile Radio and
antenna combinations