User's Manual Part 3

134
＜
Model Menu (Airplane/Glider Functions)
＞
●Selectthefunction
nameandreturntothe
precedingscreenby
touchingtheRTNbutton
orpushingtheHome/Exit
button.
<SensorTouch™>
ELEVATOR
ELEVATOR 2
V-TAIL
ELEVATOR
ELEVATOR 2
AILVATOR
FLP 2
(Camber Flap)
FLP 1
(Camber Flap)
CAMB.FLP to ELE
[Correspondingmodeltype]:Airplane/
glider, 2ailerons+1apormore
This mixing is used to correct changes (elevator
direction) generated when the camber aps (speed
aps) are used.
●Theelevatorservosupside/downsideratecanbe
adjusted.Whenthemixingdirectionisreversed
bythelinkage,adjustmentscanbemadeby
changingthemixingratepolarity(+or–).
●Amixingcurvecanbeset.
●MixingduringightcanbeturnedON/OFFby
settingaswitch.(AlwaysONat[--]setting)
●Themixingratecanbene-tunedbysettingaVR.
●Elevatorrate
adjustment
Setting method
●MovethecursortotheACT/INHitemand
touchtheRTNbuttontoswitchtothedata
inputmode.
 Turnthetouchsensortotheleftandtouch
theRTNbutton.(ONisdisplayed.)
●Whensettingaswitch,movethecursorto
the[--]itemoftheswitchandtouchtheRTN
buttontocalltheselectionscreen,andthen
selecttheswitchandsetitsONdirection.
(AlwaysONat"--"setting)
 (Foradescriptionoftheswitchselection
method,seethedescriptionatthebackof
thismanual.
●Movethecursortotheelevatorservosleft
andrightitemandtouchtheRTNbuttonto
switchtothedatainputmode.Adjustthe
mixingratewiththetouchsensor.
 TouchtheRTNbuttontoendadjustmentand
returntothecursolmovemode.
*When the mixing direction is reversed by the linkage,
adjustments can be made by changing the mixing rate
polarity (+ or –).
●WhensettingaVR,movethecursortothe
Finetuning"--"itemandtouchtheRTN
buttontocalltheselectionscreen,andthen
selecttheVR.TheVRoperationmodecan
beselected.
●Amixingcurvecanbeset.
 (Foradescriptionofthecurvesetting
method,seethedescriptionatthebackof
thismanual.)
●Overalladjustmentby
RateAandRateB.
(Currently selected condition name)
●Select[CAMB.FLPtoELE]atthemodel
menuandcallthesetupscreenshown
belowbytouchingtheRTNbutton.
●Mixingcurvesetting
*For a description of the curve setting method, see the
description at the back of this manual.
*The display screen is an
example. The actual screen
depends on the model type.
●FinetuningVRsetting
●Adjustmentrate
●Operationmode
●Group/singlemode
switching
(For more information,
refer to the description at
the back of this manual.)
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage