User's Manual Part 3

131
＜
Model Menu (Airplane/Glider Functions)
＞
●Selectthefunction
nameandreturntothe
precedingscreenby
touchingtheRTNbutton
orpushingtheHome/Exit
button.
<SensorTouch™>
CAMBER MIX
[Correspondingmodeltype]:Airplane/glider,2aileronsormore
This function adjusts the AFR (D/R) rate
of camber operation which operates the wing
camber (ailerons, camber flaps, brake flaps) in
the negative and positive directions. The aileron,
flap, and elevator rates can also be adjusted
independently by curve, and attitude changes
caused by camber operation can be corrected.
*Initial setting assigns camber operation to side lever LS.
●Theup/downsideratesoftheaileron,ap,and
elevatorservoscanbeadjustedbycurve.When
themixingdirectionisreversedbythelinkage,
adjustmentscanbemadebychangingthe
mixingratepolarity(+or-).
●MixingduringightcanbeturnedON/OFFby
settingaswitch.(AlwaysONat[--]setting)
●Adelaycanbesetforeachcondition.Acut
switchwhichcanturnOFFthedelayfunctioncan
beset.
●Thespeedoftheaileron,ap,andelevatorservos
canbeset.(INside/OUTside)
●Conditiondelay
cutswitch
●Conditiondelay
setting
●CamberAFR(D/R)setupscreen
call
(For a description of the setting method, refer
to the AFR function.)
●Servospeedsetting
(For a description of the setting
method, see the description at
the back of this manual.)
●Overalladjustmentby
RateAandRateB
●Aileronrate
adjustment
(Currently selected condition name)
●Select[CAMBERMIX]atthemodel
menuandcallthesetupscreen
shownbelowbytouchingtheRTN
button.
●Mixingcurvesetting
*For a description of the curve setting method, see the
description at the back of this manual.
*The display screen is an example. The actual
screen depends on the model type.
(Curve/ratesettingscreen)
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage