User's Manual Part 2

47
<Functions of System Menu>
● Select the function name
and return to the System
menu by touching the
RTN button or pushing the
Home/Exit button.
<SensorTouch™>
RANGE CHECK
Before a ight ground range check.
The 'range check mode' reduces the transmission
range of the radio waves to allow for a ground
range check.
*The range check mode, when activated, will continue for90
seconds unless the user exits this mode early. When the
progress bar reaches 90 second mark, the RF transmission
automatically returns to the normal operating power.
● Pushing [U.menu/Mon]key is continued.
→
Turn ON the transmitter's power switch. (First, a throttle
stick is made into a low position, and turns on a power supply.) It is displayed as "TRANSMIT
?
" .
"NO" is chosen and [RTN] is pushed.
●
[
Yes] is chosen and [RTN] is pushed.
● Remaining time of
RANGE CHECK MODE
● Range Check mode is
disabled
● Range Check mode
timer is returned to 90
Rotation Range Check method
1. Pushing [U.menu/Mon]key is continued.
→
Turn ON the transmitter's power switch.
(First, a throttle stick is made into a low
position, and turns on a power supply.)
It is displayed as "TRANSMIT
?
."
"NO" is chosen and [RTN] is pushed.
*For safety, the RANGE CHECK mode can not be selected
while the RF transmission is active.
2. In the system menu, choose the 'Range
Check' selection from the menu options.
3. The Range Check screen is displayed. To
activate the Range Check mode press
the [Yes] button. During the Range Check
period, the RF power is reduced to allow the
ground range tests to be performed.
4. The Range Check function automatically
exits after the 90 second time limit has
expired. The count down time is displayed on
the transmitter's screen. Should you complete
the range check before the 90 seconds has
pressed, press the [Exit] button.
*When the [RESTART] button is pressed, the range check
mode timer is returned to 90.
*Please note, upon expiration of the 90 seconds, or when
[Exit] is selected, the transmitter will automatically return to
the normal RF operation as noted on the display.
*Once the T18SZ is transmitting at full power, it is not
possible to enter the Range Check mode without first
switching the transmitter Off and back On. This has been
designed to prevent a modeler from inadvertently ying in
the Range Check mode.
5. When the [Exit] button is pressed, the Range
Check mode is disabled and the T18SZ will
begin transmitting at full power.
*After exiting the Range Check mode, the function cannot be
selected again. To select the Range Check mode again you
must cycle the transmitter power switch.
● Select [RANGE CHECK] at the system menu and call the setup screen shown below by touching
the RTN button.
WARNING
Do not y in the range check mode.
■
Since the range of the radio waves is short, if the model
is too far from the transmitter, control will be lost and the
model will crash.
Scrolling
● Moving cursor