User's Manual Part 2

92
<Functions of Linkage Menu>
● Select the function name
and return to the Linkage
menu by touching the
RTN button or pushing the
Home/Exit button.
<SensorTouch™>
TELEMETRY : TEMPERATURE
Displaying data from the temperature
Temperature is a screen which displays/sets
up the temperature information from an optional
temperature sensor.
The temperature of the model (engine, motor,
battery, etc.) which is ying can be displayed.
If it becomes higher or lower than the setting an
alarm and/or vibration will alert you.
*It cannot be used in FASST mode and S-FHSS mode.
*Only receiver voltage and EXT voltage can be used in
FASSTest12CH mode.
*The FASSTest18CH mode can use all the telemetry functions.
● Select [TEMPERATURE] in the TELEMETRY screen
and access the setup screen shown below by
touching the RTN button.
Scrolling
● Moving cursor
● Temperature
● The maximum and the minimum
when powering ON are shown.
It will be preset, if a cursor is
moved to this place and the
RTN button is pushed for 1
second.
● ↓ A downward arrow
will show that an alarm
will sound when the
temperature drops
below the set value.
● ↑ An upward arrow will
show that an alarm
will sound when the
temperature rises above
the set value.
Alert set : Hot warning
1. Move the cursor to the ↑ALARM item, and
it chooses from BUZZER, VOICE, INHIBIT, and
pushes RTN.
2. When not operating vibrator, it is
"
VIBRATOR"
to INHIBIT. TYPE1-3 will be chosen if it is made
to operate.
3. Move the cursor to the LIMIT [
℃
] item and
touch the RTN button to switch to the data
input mode.
4. Ajust the rate by scrolling the touch sensor.
Initial value: 100
℃
Adjustment range: 0
℃
~200
℃
(↑LIMIT
≧
↓LIMIT)
*When the RTN button is touched for one second, the rate is
reset to the initial value.
5. Touch the RTN button. (To terminate the input
and return to the original state, touch the
Home/Exit button.)
Alert set : Low-temperature warning
1. Move the cursor to the ↓ALARM item, and
it chooses from BUZZER, VOICE, INHIBIT, and
pushes RTN.
2. When not operating vibrator, it is
"
VIBRATOR"
to INHIBIT. TYPE1-3 will be chosen if it is made
to operate.
3. Move the cursor to the LIMIT [
℃
] item and
touch the RTN button to switch to the data
input mode.
4. Ajust the rate by scrolling the touch sensor.
Initial value: 0
℃
Adjustment range: 0
℃
~200
℃
(↑LIMIT
≧
↓LIMIT)
*When the RTN button is touched for one second, the rate is
reset to the initial value.
5. Touch the RTN button. (To terminate the input
and return to the original state, touch the
Home/Exit button.)
*A temperature sensor must be installed in the aircraft.
●
Select [TEMPERATURE](small font
display) in the TEMPERATURE
screen and access the setup
screen shown below by
touching the RTN button.
● The ON/OFF switch of SPEECH is
chosen.
●A setup of the temperature
on which the alarm
operates.
TYPE 1
TYPE 2
TYPE 3
"VIBRATOR" type
If the following types are selected, the transmitter
will vibrate during the warning.