Owner's manual

SELECT (CURSOR) BUTTONS: Controls used in various ways during programming. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11
Select a model: see MODEL SELECT.
Service Center. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Servo reversing: see REVERSE.
SET: To accept. Usually done by pressing and holding the dial when instructed.
Slave: Channel that moves in response to the command of the master. See Programmable mix.
Smoke system: Injects a specialized smoke oil into the hot exhaust to create air-show like smoke trails. . . . . . . . . . . .56
SNAP ROLL: (ACRO) Combines rudder, elevator and aileron movement to cause the aircraft to snap or spin at the flip
of a switch. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .47
Stick adjustments: Change stick tension and height. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15
SUB-TRIM: Used to fine tune the center or neutral point of each servo. Allows full trim function from the trim sliders for
flight trimming. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .39
SWASH AFR: (HELI,CCPM types only) Adjustment of the travel of all servos involved in the particular control's
SWASH-THR: (HELI, CCPM types only) Corrects slowing of engine speed caused by swash plate operation at aileron or
elevator operation. See throttle mixing. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 72
movement only during the movement of that control. Ex: reverse the direction of movement of collective pitch while
not affecting the direction of movement of either cyclic control. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .63
Swashplate type: (HELI). Part of the model type selection process. Selects specific heli swashplate geometry, such as one
of four available types of "CCPM." . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .61
Switch programmability: MANY features are reassignable to a variety of switches, including simply moving an auxiliary
control such as flaps from the stock dial to a switch or other location.
85