User's Manual

2. WIRING

2-12

How to fabricate the LAN cable

Fabricate the LAN cable (FR-FTPC-CY, DTI-C5E350 VCV), as shown below. (Wrap

both edges of the armor with vinyl tape.) Make sure the shield of the cable contacts

the shell of the modular plug.

Note: For a locally supplied LAN cable, expose the armor and clamp the armor with

the cable clamp.

Wrap vinyl tape. (width: 20 mm)

Cable jacket

Armor

Outer vinyl sheath

Inner vinyl sheath

Using special crimping tool

MPT5-8 (PANDUIT CORP.),

crimp the modular plug.

Finally check the plug visually.

Expose inner vinyl sheath.

Remove the outer sheath by

approx 25 mm. Be careful

not to damage inner shield

and cores.

Fold back the shield, wrap it

onto the outer sheath and

cut it, leaving 9 mm.

25 mm

approx. 9 mm

approx. 11 mm

Drain wire

Fold back drain wire and

cut it, leaving 9 mm.

Straighten and flatten the

core in order and cut them,

leaving 11 mm.

Insert the cable into the modular

plug so that the folded part of

the shield enters into the plug

housing. The drain wire should

be located on the tab side of

the jack.

Modular plug