Assembly Instructions ASSEMBLY RATING Tools Required for Assembly: The Assembly Rating is a 5-point system that] shows the degree of effort needed in Phillips Screwdriver erg——= assembling a specific product (with 1 being (Not Included) easy and 5 being difficult). For most products,two persons are recommended.
90-DAY LIMITED REPLACEMENT PARTS WARRANTY This item comes with a 90-day limited replacement parts warranty to the original purchaser of new products against defects in materials and workmanship for a period of ninety (90) days from the date of receipt. This warranty is not transferable.
ER] Lal FOR YOUR FURNITURE TO LAST CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE, BASIC ASSEMBLY TECHNIQUES 1t is highly recommended that the Position each part correctly and insert Use cardboard or carpet area when assembly should be done near the screws or bolts into their respective assembling furniture to prevent area of its intended location. Make holes by hand tighten or using the scratches.
PER-ASSEMBLY INTRODUCTION Unless you are particularly adept at assembling furniture, we understand building ready-to-assemble furniture can be a frustrating experience for some. To help avoid confusion and to make the assembly process quicker and smoother, we have provided some helpful tips. Before you begin the assembly, please read the following : 1.
CAM LOCK FASTENER ASSEMBLY INSTRUCTIONS Secure the threaded end of the cam bolt by using a screwdriver. Tun right (clockwise) to tighten. Note:Every cam lock bolt must have a cam lock connector in order to fasten the parts together. Align the cam connector with its side opening (or arrow) pointing to the small ~~ drilled hole. Two parts should fit snugly ~ >. a against each other. Sn | Insert the cam lock 9 . SI bolt into the per-driiled hole above the cam connector.
(1) 1pc (9) 1pc , (17) PCs (2) 1pc | (10) PCs | (18) 1pc (3) 1pc (11) 1pc (19) 1pc (4) 1pc 1 (12) apes ! (20) PCs (6) 1pc (13) 1pc (21) 1pc (6) 1pc (14) PCs (7) 1pc (15) PCs (8) 1pc «+ (16) PCs PARTS LIST Before you begin,please read"Assembly and Care Introduction"and "Cam Lock Fastener Assembly Instructions".
HARDWARE LIST Glue: For securing please apply wood dowel first before Ipc inserting into panel Due fo the size and/or weight of this product,it is highly recommended that the assembly should be done near the area of its intended location.Make sure you have enough space to move around during the assembly.
ASSEMBLY INSTRUCTIONS &, SAFETY STRAP TO PREVENT TIP OVER SAFETY STRAP TO PREVENT TIP-OVER Drywall: Select a location where you want the table to be mounted. Place the assembled table against the wall and, on the wall, mark the location where the anchor will be placed. Drill a hole slightly smaller then the size of the screw . Push the anchor as far as it will go with your finger. Tap gently with a hammer until the anchor is flush with the wall surface.
