Installation Guide

ASSEMBLY INSTRUCTIONS
BB
D
D
D
PACKAGE CONTENTS
x 5 Shelf x 1 Bottom Shelf
B
x 36 +2 extra
Tapered Lock
G
A
E
F
x 6
x 3
Middle
Pole(with
pole connector
preassembled)
Bottom Pole
(with feet leveler
preassembled)
x 3
Top Pole
(with pole
cap and
pole connector
preassembled)
C
D
Lower Short Pole
x 1
B
D
C
G
G
D
A
K
K
K
K
K
K
B
B
Warning:
Maximum weight capacity per shelf is
70lbs when weight is equally
distributed.
Maximum entire unit weight capacity is
420bs when equally distributed on
feet levelers.
Failure to follow these instructions may
result in serious injury or death of
yourself and people around you.
Some of the part are heavy and/or has
shape edge, please install it carefully to
avoid hurt you and people around you.
Caution:
Do not stand on or climb on the
shelving unit.
Place heavier items on lower shelves
and lighter ones on top shelves.
A
E
F
F
F
G
5. Screw middle pole (F) onto bottom pole(G), hand tighten.
Then screw another middle pole(F) onto the last middle
pole, hand tighten.
6. Screw top pole (E) onto
middle pole(F), hand tighten.
8. Place the shelf liner on top of the shelf。Finish.
7. Repeat steps 1-3 for the remaining shelves.
4. Repeat steps 1-3 for the second shelf (A).
3. Turn assembly upright and push the bottom shelf (B) firmly
onto the tapered locks (C). Note: Make sure the lip of
bottom shelf (B) is facing down and the levelers (H) on
bottom poles (G) are on the floor. Screw lower short pole
(D) into bottom shelf(B).
1. With the tapered end facing up, snap the two halves of a
tapered lock (C) at the desired height on bottom pole (G).
Repeat for the remaining bottom poles (G), making sure
the tapered locks (C) are installed at the same grooved
line on each bottom pole (G).
2. Rest bottom shelf (B) on its side, then insert the bottom
poles (G) through the corner holes of the bottom shelf (B).
H
I J K L
6-Tier Fanshaped Corner Rack
6TWL72
x 15
Black plastic spacer
(NOTE: Discard the black plastic spacers K.
These between each shelf are only for packing
purpose , not for assembling.)
Shelf liner
x 6
Nylon strap x 2
Wall anchor x 4 Screws x4
H
I
J
IMPORTANT:
Installing wall straps is not necessary, but it is highly recommended.
Step 1. Loop the Nylon straps (H) around the middle side of top shelf
nearest to the wall.Use 1 per side.
Step 2. Pull the Nylon Straps (H) against the wall and mark holes where
you’d like to install your anchors (I) or screws (J) TIP！
Use a stud finder to determine if you are installing into drywall or wood wall.
FOR DRYWALL
Drill a hole in the wall at the marked point roughly the depth of the anchor (I).
Screw the anchor (I) into hole until flush.
Screw screws (J) into anchor (I) until snug.
FOR WOOD STUDS
Drill a pilot hole into the wall at the marked point.
Screw screws (J) into holes until flush.