Installation Manual

ManualsBrandsFujitsu ManualsRemote ControlsWireless Remote for 2' x 2' Cassettes

PART NO. 9371972084-02

AIR CONDITIONER

REMOTE CONTROLLER

(WIRELESS TYPE)

UTY-LNHUM

Contents

1. SAFETY PRECAUTIONS ............................................. 2

2. ACCESSORIES ............................................................ 2

3. INSTALLING THE REMOTE CONTROLLER ............... 2

3.1. Load batteries (R03/LR03 x 2) ............................... 2

3.2. Installing the remote controller holder ................... 2

4. FUNCTION SETTING ................................................... 3

5. SELECTING THE REMOTE CONTROLLER SIGNAL

CODE ............................................................................ 5

6. TEST OPERATION ....................................................... 6

INSTALLATION MANUAL

For authorized service personnel only.

EnglishFrançaisEspañol

9371972084-02_IM_en.indd 19371972084-02_IM_en.indd 1 9/7/2010 7:20:14 PM9/7/2010 7:20:14 PM

Summary of content (6 pages)

PAGE 1
Español For authorized service personnel only. English INSTALLATION MANUAL Français AIR CONDITIONER REMOTE CONTROLLER (WIRELESS TYPE) UTY-LNHUM Contents 1. SAFETY PRECAUTIONS ............................................. 2 2. ACCESSORIES ............................................................ 2 3. INSTALLING THE REMOTE CONTROLLER ............... 2 3.1. Load batteries (R03/LR03 x 2) ............................... 2 3.2. Installing the remote controller holder ................... 2 4.
PAGE 2
1. SAFETY PRECAUTIONS 3. INSTALLING THE REMOTE CONTROLLER • Let the customer keep this installation manual because it is needed when the air conditioner or remote controller is serviced or moved. 3.1. Load batteries (R03/LR03 x 2) This mark indicates procedures which, if WARNING improperly performed, might lead to the death or serious injury of the user. • For the air conditioner to operate satisfactorily, install it as outlined in this installation manual.
PAGE 3
(1) Mount the holder. (2) Set the remote controller. Insert Press in Screws STEP 2 SELECTING THE FUNCTION NUMBER AND SETTING VALUE Refer to the indoor unit installation manual for details on the function numbers and setting values. Selecting the function number and setting value (3) To remove the remote controller (when use at hand). Slide up Pull out 4. FUNCTION SETTING Perform the “FUNCTION SETTING” according to the installation conditions using the remote controller.
PAGE 4
Remote controller signal code External input 10) control Room 11) temperature control switching 9) 44 z z z z 46 z z z z 48 z z z z Setting description 4-way 3-way 22 ♦ 1) Filter sign The indoor unit has a sign to inform the user that it is time to clean the filter. Select the time setting for the filter sign display interval in the table below according to the amount of dust or debris in the room.
PAGE 5
Room temperature is controlled by either indoor unit temperature sensor or remote controller unit sensor. 9) Remote controller signal code Change the indoor unit Signal Code, depending on the remote controllers. (♦... Factory setting) Setting description Function number A B C D 44 ♦ Setting value 00 01 02 03 10) External input control “Operation/Stop” mode or “Forced stop” mode can be selected. (♦...
PAGE 6
. TEST OPERATION The outdoor unit may not operate depending on the room temperature. In this case, press the test run button on the remote controller while the air conditioner is running. (Point the transmitter section of the remote controller toward the air conditioner and press the test run button with the tip of a ballpoint pen, etc.) Transmitter section Test run button To end test operation, press the remote controller START/ STOP button. En-6 9371972084-02_IM_en.