Full Product Manual

7
18
ACTUAL SPRAYING TECHNIQUES.
The Spray Gun should be held perpendicular to the surface at all
times. HOLD THE GUN NO MORE THAN 8” (20cm) AWAY FROM
THE SURFACE TO BE PAINTED.
CORRECT METHOD
Start off the piece. Pull the Trigger and move the Spray Gun in the
direction you want to spray. Continue off the edge of the piece on the
other end before releasing the Trigger. Between each successive pass,
overlap by about a half.
INCORRECT METHOD
CAUTION: Never, for any reason, point the Spray Gun directly at
the face, or head of a person.
TURBINE CARE AND MAINTENANCE
FUJI SPRAY PLATINUM SERIES TURBINES
All PLATINUM Turbines are built with the Fuji Spray Heat Dissipation
Box™. Excess heat is channeled directly to this outlet located at rear
of the case. Note: There is no maintenance required for the Heat Dissi-
pation Box™.
Q5 PLATINUM VARIABLE SPEED CONTROL DIAL
The Q5 PLATINUM Turbine is installed with Variable Speed Control Dial
on the front of your Turbine case. This feature offers the ability to adjust
the psi to the optimum needed to perfectly atomize your coating and yet
reduce the overspray/bounceback to an absolute minimum.
Please refer to “www.fujispray.com/technical” or the Fuji Spray “FAQ”
page. Here you will find detailed instructions on the most efficient way to
use this Dial.
FILTER(S)
It is important to clean or replace your filters regularly. Operating the
Turbine unit with clogged or dirty filters will cause the Turbine to overheat
and result in premature failure. The Fuji HVLP Turbines have either 1 or
2 Filters. To remove, simply pull the Filters out from Filter Enclosure.
Wash in warm soapy water and dry before replacing.
All Fuji Filters are a friction fit. The Filter must fill the entire Filter Enclo-
sure. NOTE: Mini-Mite GOLD Turbine has two square filters, fine and
coarse. The fine Filter is installed to the left side and the coarse to the
right side (as seen looking at the front of the Turbine where the Hose is
connected).
Cleaning your filters regularly is essential to maintaining your
Turbine. It is always a good idea to have a spare pair of filters on
hand.
Turbine Filter part numbers:
- Mini-Mite GOLD Turbine (square shape filters) - Part # 4009-2
- Mini-Mite PLATINUM Turbine (semi-circle shape filters) - Part # 7224-2
- Q GOLD and PLATINUM Turbine filter- Part # 5029
All HVLP Turbines are designed for intermittent use. When taking a
break between coats or stepping aside to refill your cup, it’s good practice
to turn the Turbine off during this time. This allows the machine to cool
off.