Side by Side Refrigerator Manual

ManualsBrandsFrigidaire ManualsRefrigeratorSide by Side FRS23KF5CS0

INSTALLATION - CONNECTING ICE MAKER TO WATER SUPPLY

WARNING WARNING

WARNING

To avoid electric shock, which can cause death or

severe personal injury, disconnect the refrigerator from

electrical power before connecting a water supply line

to the refrigerator.

CAUTION CAUTION

CAUTION

To Avoid Property Damage:

• Copper tubing is recommended for the water supply

line. Water supply tubing made of ¼” plastic is not

recommended since it greatly increases the potential

for water leaks. Manufacturer will not be responsible

for any damage if plastic tubing is used for supply

line.

• DO NOT install water supply tubing in areas where

temperatures fall below freezing.

• Chemicals from a malfunctioning softener can

damage the ice maker. If the ice maker is connected

to soft water, ensure that the softener is maintained

and working properly.

IMPORIMPOR

IMPOR

ANTANT

ANT

Ensure that your water supply line connections comply

with all local plumbing codes.

Before Installing The Water Supply Line, You Will Need:

• Basic Tools: adjustable wrench, flat-blade screwdriver,

and Phillips

screwdriver

• Access to a household cold water line with water pressure

between 30 and 100 psi.

• A water supply line made of ¼ inch (6.4 mm) OD, copper

tubing. To determine the length of copper tubing needed,

you will need to measure the distance from the ice maker

inlet valve at the back of the refrigerator to your cold water

pipe. Then add approximately 7 feet (2.1 meters), so the

refrigerator can be moved out for cleaning (as shown).

• A shutoff valve to connect the water supply line to your

household water system. DO NOT use a self-piercing type

shutoff valve.

• A compression nut and ferrule (sleeve) for connecting the

water supply line to the ice maker inlet valve.

NOTENOTE

NOTE

Water line kit number 5303917950, available from your

appliance dealer at additional cost, contains 25 feet (7.6

meters) of ¼ inch OD copper tubing, a saddle type shutoff

valve (nonpiercing), (2) ¼ inch brass compression nuts, (2)

ferrules/sleeves, and instructions for installing a water

supply line.

To Connect Water Supply Line To Ice Maker Inlet Valve

1. Disconnect refrigerator from electric power source.

2. Place end of water supply line into sink or bucket. Turn ON

water supply and flush supply line until water is clear. Turn

OFF water supply at shutoff valve.

3. Unscrew plastic cap from water valve inlet and discard

cap.

4. Slide brass compression nut, then ferrule (sleeve) onto

water supply line, as shown.

5. Push water supply line into water valve inlet as far as it will

go (¼ inch). Slide ferrule (sleeve) into valve inlet and

finger tighten compression nut onto valve. Tighten another

half turn with a wrench; DO NOT over tighten.

6. With steel clamp and screw, secure water supply line to

rear panel of refrigerator as shown.

7. Coil excess water supply line (about 2½ turns) behind

refrigerator as shown and arrange coils so they do not

vibrate or wear against any other surface.

8. Turn ON water supply at shutoff valve and tighten any

connections that leak.

9. Reconnect refrigerator to electrical power source.

10. To turn ice maker on, lower wire signal arm (see ice maker

front cover for ON/OFF position of arm).

IMPORIMPOR

IMPOR

ANTANT

ANT

It takes approximately 24 hours for the ice maker to begin

producing ice. Air in new plumbing lines may cause ice

maker to cycle two or three times before making a full tray

of ice. New plumbing may cause ice to be discolored or

have poor flavor. Discard ice made during the first 24

hours.