Use and Care

IMPORTANT
When replacing the doors on the lower
hinge, they must be installed at a 90 degree
angle.

NOTE
When reinserting the water tube and replac-
ing the top hinge cover, use care to be sure
you do not kink the tube.

NOTE
Upon replacement, the tube needs to be
fully inserted up to the marking line.
12
DOOR REMOVAL INSTRUCTIONS
To reinstall the refrigerator
doors:
Water
Line
Water
Line
Insert
tube up
to the
marking
line
Press
Press
Bottom of the Doors
For
RIGHT DOOR,
turn pin 90˚
counter-
clockwise
For
LEFT DOOR,
turn pin 90˚
clockwise
1 Replace the lower hinge screws.
2 Holding the door at a 90 degree angle,
drop the pin down into the center hinge
opening. Rotate it slightly in either
direction until the door falls down into
place.
5 Reconnect the harnesses.
6 Replace the top hinge covers.
7 Reconnect electrical power cord to the
wall outlet.
To reset door pin:
If doors are removed at less than a 40 degree
angle, the pin returns to the home position. It
can be reset by turning the door upside and
using a 5/32” Allen wrench to rotate the left
hand pin 90 degrees clockwise and the right
hand pin 90 degrees counterclockwise.
Pin
Mechanism
Bottom
Hinge
Opening
Doors
at 90º
(Door Bottom)
3 Reinstall top hinge.
4 Insert the water line in the top left tunnel
pushing from the front to the back of the
unit.
Once the door pins are reset, follow the steps
“To reinstall the refrigerator doors”.