Installation guide

ManualsBrandsFrigidaire ManualsRoom air conditionerOfficial Frigidaire room air conditioner

Attach foam adhesive seal:

Attach foam adhesive seal along the bottom of the curtain bottom channel (FIG.8).

A. Curtain housing

B. Foam adhesive seal

FIG.9 A_g_ket fsCeacbuineetyseated

on edge of inner silt.

_binet

_'neUr°_,, wintdow [--J Bracket

outer sill

Install Cabinet into Window:

1. Center empty cabinet in window:

FIG.10

A. Window sash

......................................A

...................B

......................C

B. Empty cabinet

C. Window channel

Check that lower rail of air conditioner cabinet is behind and against back side of window sill. Maintain a firm hold on

the air conditioner cabinet (FIG.9). Lower window sash to hold the cabinet in place. Measure the distance between the

right side of the cabinet and the inside of the window channel (FIG.10). Repeat for the left side. Adjust the cabinet until

the distance on each side is the same.

2. Attach the cabinet to window:

A: For wooden window:

Use a 3/16" drill bit to drill three starter holes 3/8" deep through the three holes in the cabinet and into the window sill,

and drill one starter hole 318" deep through the hole in the middle of top rail and into the window frame (FIG.11). Attach

cabinet to window with three #10 x 112"pan-head Phillips screws and one #10 X 314" round-head screw (FIG. 11).

B: For Vinyl-Clad window:

Use a 1/8" drill bit to drill one hole through the hole in the middle of top rail and into the window frame. Attach cabinet

to window with one #10 x 3/4" round-head Phillips screw (FIG.11). Place two safety locks into the holes that located

in the bottom of the cabinet and drive two locking screws through the safety locks into the cabinet as shown (FIG.12)

3. Check that air conditioner cabinet is tilted back 5/16" to 3/8" so that water could run to the outside (See FIG.13).

FIG.11 ..... FIG.12

A A

A. #10 X 1/2" pan-head Phillips screws

B. #10 X 3/4" round-head screw

C. Window channel

Only for Vinly-Clad Window

FIG.13

w Sash

ide Louvers

#10 X 1/4" pan-head Phillips screws

Safety Lock Window Sill

Attach Side Curtains to Window Frame:

1. Extend the side curtains out against the window frame

(FIG.11).

2. Drill holes and drive locking screws:

A: For wooden windows:

Use a 3/32" drill bit to drill 4 starter holes through the holes in

the side curtains into the window. Drive four #10 X 314" locking

screws through the holes in the side curtains into the window

sill and window frame(FIG.14A, FIG.14B).

B: For Vinyl-Clad windows:

Use a 118"drill bit to drill two holes through the holes in the

side curtains into the window frame as shown (FIG.14A).

Drive two #I0 X 314" locking screws through the holes in the

FIG.14B

FIG.14A

B _

A. Window channel

A. #10 X 314" round-head

B. left-hand curtain

C. #10 X 314" round-head screw

B. Slotted hole in the

side curtains into the window sash (FIG. 14A) screw bottom of the curtain

3. Trim the weather seal (6"X314"X1112") with a proper length, peel off the protective backing and plug any gaps if

needed as shown (FIG.14B).