All about the Use & Care of your Gas Range TA B L E O F C O N T E N T S Important Safety Instructions ........................... 3-6 Setting Oven Controls .................................. 11-15 Features at a Glance ......................................... 7 Self-Cleaning ..............................................16-17 Before Setting Oven Controls .............................. 8 Care & Cleaning ..........................................18-20 Before Setting Surface Controls .................
PRODUCT RECORD AND REGISTRATION Contents Product Registration ...................................................... 2 Important Safety Instructions ............................ 3-6 Features at a Glance .............................................. 7 Before Setting Oven Controls .................................. 8 Removing, replacing & arranging the oven racks ........... 8 Before Setting Surface Controls .............................. 9 Cookware material types ............................................
IMPORTANT SAFETY INSTRUCTIONS Read all instructions before using this appliance. Do not attempt to install or operate your appliance until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a WARNING or CAUTION statement based on the risk type. Definitions This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.
IMPORTANT SAFETY INSTRUCTIONS WARNING NEVER use this appliance as a space heater to heat or warm the room. Doing so may result in carbon monoxide poisoning. NEVER cover any slots, holes or passages in the oven bottom or cover an entire rack with materials such as aluminum foil. Doing so blocks air flow through the oven and may cause carbon monoxide poisoning. Aluminum foil linings may trap heat, causing a fire hazard.
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT INSTRUCTIONS FOR USING YOUR COOKTOP WARNING Use Proper Flame Size—Adjust flame size so it does not extend beyond the edge of the utensil. The use of undersized utensils will expose a portion of the burner flame to direct contact and may result in ignition of clothing. Proper relationship of utensil to flame will also improve efficiency. • Know which knob controls each surface burner.
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT INSTRUCTIONS FOR CLEANING YOUR RANGE • Clean the range regularly to keep all parts free of grease that could catch fire. Pay particular attention to the area around each surface burner. Do not allow grease to accumulate. Grounding type wall receptacle • Kitchen cleaners and aerosols—Always follow the manufacturer’s recommended directions for use. Be aware that excess residue from cleaners and aerosols may ignite causing damage and injury.
FEATURES AT A GLANCE 2 1 Your gas range features include: NOTE The features shown may vary from your appliance according to model type & color. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 7 Electronic oven control with kitchen timer. Oven light switch (some models). Left front burner valve and control knob. Left rear burner valve and control knob. Right front burner valve and control knob. Right rear burner valve and control knob.
BEFORE SETTING OVEN CONTROLS Oven vent location Types of oven racks The oven vent is located below the control panel (See Fig. 1). When the oven is on, warm air passes through this vent. This venting is necessary for proper air circulation in the oven and good baking results. Do not block the oven vent. flat handle oven rack oven vent location flat oven rack Fig. 1 offset oven rack Removing, replacing & arranging racks To remove - pull the rack forward until it stops.
BEFORE SETTING SURFACE CONTROLS Using proper cookware Set proper burner flame size For best cooking results, cookware should have flat bottoms that rests level on the burner grate. Before using cookware, check for flatness by rotating a ruler across the bottom of the cookware (Fig. 1). The color of the flame is the key to proper burner adjustment. A good flame is clear, blue and hardly visible in a well-lighted room. Each cone of flame should be steady and sharp.
SETTING SURFACE CONTROLS Setting surface controls Your gas appliance may be equipped with different sized surface burners. The ability to heat food quicker and in larger volumes increases as the burner size increases. It is important to select cookware that is suitable for the amount and type of food being prepared. The smaller simmer burner (some models) is best suited for simmering delicate sauces, etc. The standard size (9,500 BTU) burners may be used for most surface cooking needs.
OVEN CONTROL FUNCTIONS READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE OVEN. For satisfactory use of your oven, become familiar with the various pad features and functions of the oven as described below. Feature indicator lights— These indicator lights show which feature is active. Broil pad— Use to select the variable broil feature.
SETTING OVEN CONTROLS Setting the minute timer Changing between continuous bake setting or 12-Hour Energy Saving feature 1. Press timer on-off. 2. Press the to increase the time in one minute increments. Press and hold the to increase the time in 10 minute increments. The timer can be set for any amount of time from 1 minute to 11 hours and 59 minutes. Note: If the pad is pressed first, the timer will advance to 11 hours and 59 minutes. 3.
SETTING OVEN CONTROLS Setting bake The oven can be programmed to bake at any temperature from 170°F to 550°F (77°C to 287°C). The factory preset automatic bake temperature is 350°F (177°C). To set bake 1. Press bake. "— — —" appears in the display. 2. Within 5 seconds, press the or . The display will show "350°F (177°C)." By pressing and holding the or , the temperature can then be adjusted in 5°F increments (1°C if the control is set to display Celsius). 3.
SETTING OVEN CONTROLS Setting broil Use the broil feature to cook meats that require direct exposure to flame heat for optimum browning results. When broiling always remember to arrange the oven racks while oven is still cool. Position the oven rack as suggested in the broil settings table (See Fig. 3). Insert 6 5 4 To set broil 1. Arrange the oven rack while oven is still cool. 2. Press broil. " — — "will appear in display. 3. Press and hold the or setting level appears in the display.
SETTING OVEN CONTROLS Adjusting the oven temperature Setting oven lockout Your appliance has been factory calibrated and tested to ensure an accurate baking temperature. For the first few uses, follow your recipe times and temperature recommendations carefully. If you think the oven is cooking too hot or too cool for your recipe times, you can adjust the control so the oven cooks hotter or cooler than the temperature displayed. To adjust oven temperature: 1. Press bake. 2.
SELF-CLEANING Self-cleaning A self-cleaning oven cleans itself with high temperatures (well above normal cooking temperatures) which eliminate soils completely or reduces them to a fine powdered ash you can wipe away with a damp cloth. IMPORTANT Adhere to the following self-clean precautions: • DO NOT use oven cleaners or oven protective coatings in or around any part of the oven interior. • DO NOT clean the oven door gasket (See Fig. 1).
SELF-CLEANING Setting a self-clean cycle 1. Be sure the clock displays the correct time of day. 3. Press clean. “---” appears in the display. 4. Press the or pad once. “3:00” will appear in the display indicating that a 3 hour self-clean time is set. To change to a 2 hour self-clean time press once (2:00 appears in the display). (Some models) For a 4 hour self-clean time press until (4:00 appears in display). 5.
CARE & CLEANING Cleaning recommendation table Surface type Recommendation • • • • Use hot, soapy water and a cloth. Dry with a clean cloth. Control knobs Painted body parts Painted decorative trim Aluminum, plastic or vinyl trim pieces For general cleaning, use hot, soapy water and a cloth. For more difficult soils and built-up grease, apply a liquid detergent directly onto the soil. Leave on soil for 30 to 60 minutes. Rinse with a damp cloth and dry.
CARE & CLEANING Cleaning the cooktop and surface burners CAUTION • To avoid possible burns DO NOT attempt any of the cleaning instructions provided below before turning OFF all of the surface burners and allow them to cool. • Any additions, changes or conversions required in order for this appliance to satisfactorily meet the application needs must be made by an authorized qualified Agency. Routinely clean the cooktop. Wipe with a clean, damp cloth and wipe dry to avoid scratches.
CARE & CLEANING Replacing oven light CAUTION Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a leather-faced glove for protection against possible broken glass. The light bulb is located at the rear of the oven cavity and is covered with a glass shield held by a wire holder. The glass shield must be in place whenever the oven is in use. Special door care instructions - Most oven doors contain glass that can break.
Solutions to common problems • Problem BEFORE YOU CALL Solution Poor baking results. • Many factors affect baking results. Make sure the proper oven rack position is used. Center food in the oven and space pans to allow air to circulate. Allow the oven to preheat to the set temperature before placing food in the oven. Try adjusting the recipe's recommended temperature or baking time. If you feel the oven is too hot or cool, see “Adjusting the oven temperature” section in this Use & Care Guide.
BEFORE YOU CALL • Solutions to common problems • Problem Solution Soil not completely removed after selfcleaning cycle. • Failure to clean bottom, front top of oven, frame of oven or door area outside oven seal. These areas are not in the self-cleaning area, but get hot enough to burn on residue. Clean these areas before the self-cleaning cycle is started. Burned-on residue can be cleaned with a stiff nylon brush and water or a nylon scrubber. Be careful not to damage the oven gasket.
NOTES 23
MAJOR APPLIANCE WARRANTY Your appliance is covered by a one year limited warranty. For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions. Exclusions This warranty does not cover the following: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13.