Owners Manual

7
INSTALLATION
Raise
Door Opening
Position your unit to allow easy access to
a counter or table when removing food.
For the best use of drawers and freezer
baskets, position the appliance where
both doors can fully open.
Guidelines for final positioning
of your unit:
• Rest all 4 corners of the cabinet
firmly on the floor.
• Level the cabinet at the front and rear.
• Tilt the sides ¼" (6 mm) from front
to back (to ensure the doors close
and seal properly).
• Align the doors with each other
and level.
Meet all of these conditions by
raising or lowering the adjust-
able front rollers.
To level the cabinet using the front rollers:
1. Open both doors and remove
the toe grille (see “Toe Grille
Installation and Removal” in the
“Installation” section).
2. Close the doors and use a flat-blade
screwdriver or ⅜" socket wrench to
raise or lower the front rollers.
3. Ensure both doors are bind-free with
their seals touching the cabinet on all
4 sides.

NOTE
The doors are designed to shut by
themselves within a 20 degree opening.
To level the doors using the adjustable
lower hinge:
1. Before leveling either door, remove
the set screw that locks the door
height into position. (The door
cannot be adjusted without the set
screw removed).
2. If the refrigerator door is lower than
the freezer door, raise the refrigera-
tor door by turning the adjustment
screw counterclockwise using a
7
/
16
"
wrench. (See illustration.)
3. If the freezer door is lower than the
refrigerator door, raise the freezer
door by turning the adjustment
screw counterclockwise using a
7
/
16
"
wrench. (See illustration.)

NOTE
Some models will not have a set screw. For
those models follow steps 2 through 4.