Use and Care Manual
Table Of Contents
- Introduction
- Important Safety information
- Features (2-Door Model)
- Features (3-Door Model)
- Installation
- Door Removal
- Door Handle Installation (some models)
- Water Supply Connection
- Controls and Settings
- Automatic Water Dispenser
- Ice Maker
- Storage Features
- Storing Food and Saving Energy
- Normal Operating Sounds
- Filter Replacement
- Care and Cleaning
- Troubleshooting
- Limited Warranty
33
TROUBLESHOOTING
Concern Potential Cause Common Solution
Water/Moisture/Frost Inside Refrigerator
Moisture
collects on
inside of
refrigerator
walls.
• Weather is hot and humid.
• Flipper mullion
• The rate of frost buildup and
internal sweating increases.
• Adjust flipper mullion. (See “Flipper
Mullion” in INSTALLATION.)
Water
collects on
bottom side
of drawer
cover.
• Vegetables contain and
give o moisture.
• It is not unusual to have moisture on
the bottom side of the cover.
• Both crispers contain an automatic
humidity control, which should
adjust automatically to the varying
levels of moisture inside the
drawer without creating additional
condensation or drying out the air
inside the crisper drawer, works with
various types of produce. If excess
moisture is noticed, check to verify
humidity membrane is not damaged
and replace as necessary.
Water
collects in
bottom of
drawer.
• Washed vegetables
and fruit drain while
in the drawer.
• Dry items before putting them in
the drawer. Water collecting in
bottom of drawer is normal.
Water/Moisture/Frost Outside Refrigerator
Moisture
collects on
outside of
refrigerator
or between
doors.
• Weather is humid. • This is normal in humid weather.
When humidity is lower, the
moisture should disappear.
Food/Drinks in Fresh Food Compartment
Food is
freezing.
• Temperature setting is
too low.
• Temperature sensor is
covered by food (right
side of fresh food area).
• Food is covering the
air ports.
• Move the setting to a higher degree.
• Allow space for air flow to the sensor.
• Allow space between the air ports
and the food.