Manual

POSSIBLE CAUSE SOLUTIONOCCURRENCE

DRYER

Dryer does not start. Electrical power cord is not securely Make sure the plug fits tightly in wall outlet.

plugged in or plug may be loose.

House fuse blown or circuit breaker Reset circuit breaker or replace fuse.

tripped.

Make sure electrical line is not overloaded and the dryer

is on a separate circuit.

Thermal limiter tripped. Call authorized service person for replacement.

Dryer runs but won't There are 2 house fuses in the dryer Replace fuse.

heat. circuit. If 1 of the 2 fuses is blown, the

drum may turn but the heater will not

operate.

Gas supply valve is not open (gas models). Check to make sure supply valve is open. See

INSTALLATION INSTRUCTIONS for procedure.

Dryer does not have enough air supply to See INSTALLATION INSTRUCTIONS.

support the burner flame (gas models).

LP gas supply tank is empty or there has Refill or replace tank.

been a utility interruption of natural gas

(gas models). Dryer should heat when utility service is restored.

Drying cycle takes too Lint screen is clogged with lint. Make sure all lint has been removed from the dryer lint

Iong, outsideofthedryer screen before starting each cycle.

feels too hot or smells

hot. Exhaust duct requirements have not been Exhaust duct must be at least 4 inches in diameter and

met. made of rigid or flexible metal.

When in place, the duct must have no more than two

90 ° bends and must not exceed length listed in

INSTALLATION INSTRUCTIONS.

Electric dryer is connected to a 208 volt Dryingtimewillbe 20% Iongerthan drying ona 240volt

circuit, circuit.

Drying procedures have not been See Drying Procedures.

followed.

Outside exhaust hood or exhaust duct Clean out any obstruction.

may be clogged or restricted.

High humidity. Use a dehumidifier near the dryer.

Excessive wrinkfing.

Dryer is overloaded. Do not overload. See Drying Procedures .

Items left in dryer too long. Remove items as soon as cycle ends.

Insufficient sorting of items. See Drying Procedures .

Drying temperature too high. Follow fabric care label instructions.