Manual

.... - Winterizing Instructions

Follow Win terizing

Instructions for cold

wea th er care.

Ifthe laundry center isstored in an areawhere freezing can occur or moved in freezing

temperatures, followthese winterizing instructions to prevent damageto the laundry

(:enter:

1. Turn off water supply faucets.

2. Disconnect hosesfrom water supply and drain water from hoses.

3. Plug electrical cord into a properly grounded electrical outlet.

4. Add I gallon nontoxicrecreationalvehicle(RV)antifreezetoempty wash drum.

Close door.

5. Set cycle selector knob at a spin setting. Pull out knob and let washer spin for

1 minute to drain out all water. Not all of the RV antifreeze will be expelled.

6. Push in knob, unplug electrical power cord, dry tub interior, and close door.

7. Store washer in an upright position.

8. To remove antifreeze from washer after storage, run empty washer through a

complete cycle using detergent. Do not add wash load.

Avoid Service Checklist

Before calling for service, review this list. It may save both time and expense. The list includes common concerns that are not the

result of defective workmanship or materials in this laundry center.

OCCURRENCE

POSSIBLE CAUSF / SOLUTION

NOMSE

"Clicking" noise. * A normal sound made by the timer.

High pitch "jet engine" noise. • A certain amount of motor whine is normal during the spin cycle.

Rattling and clanking noise. • Foreign objects such as coins or safety pins may be in drum or pump. Stop washer

and check drum. If noise continues after washer is restarted, objects may be in

pump. Call your authorized servicer.

Belt buckles and metal fasteners are hitting wash drum. To prevent unnecessary

noise and damage to drum, fasten fasteners and turn items inside out.

Squealing sound or hot rubber odor. • Washer is overloaded. Do not overload washer. Stop washer and reduce load.

Thumping sound. • Heavy wash loads may produce athumping sound. This is usually normal. If sound

continues, washer is probably out of balance. Stop washer and redistribute wash

load.

Vibrating noise. • Washer isnot resting firmly on floor. Move washer so it restsfirmly on floor. Adjust

leveling legs and tighten lock nuts.. SeeINSTALLATIONINSTRUCTIONSfor details.

Shipping bolts and foam block have not been removed during installation. See

INSTALLATIONINSTRUCTIONSfor removing shipping bolts and foam block.

Wash load unevenly distributed in drum. Stop washer and rearrange wash load.