Manual

Door Removal (Upright Models)
• Unplug the unit
• Gently lay freezer on its back, on a rug or blanket.
• Remove two base screws and base panel. Remove wire from
clips on bottom of cabinet, if required.
• Unplug connector, if required, by holding the cabinet connector
in place and pulling the door connector out.
• Remove the bottom hinge screws.
• Remove the plastic top hinge cover.
• Remove the screws from the top hinge.
• Remove the top hinge from the cabinet.
• Remove the door and bottom hinge from the cabinet.
• To replace door, reverse the above procedures and securely
tighten all screws to prevent hinge slippage.
Base
Base Panel Screws
Hinge Screws
Cabinet Connector
Lid Removal (Chest Models)
• See lid removal instructions on the back of the cabinet.
Setting the Temperature Control
Cool Down Period
• For safe food storage, allow four (4) hours for freezer to cool
down completely. The freezer will run continuously for the first
several hours. Foods that are already frozen may be placed in
the freezer after the first few hours of operation. Unfrozen foods
should NOT be loaded into the freezer until freezer has operated
for four (4) hours.
• When loading freezer, freeze only three (3) pounds of fresh food
per cubic foot of freezer space at one time. Distribute packages
to be frozen evenly throughout the freezer. It is not necessary to
turn the control knob to a colder setting while freezing food.
Electromechanical Temperature Control (Chest and
Some Upright Models)
The electromechanical temperature control is located inside the
freezer on upright models, and on the left exterior wall on chest
models (see figure 1). The temperature is factory preset to provide
satisfactory food storage temperatures. However, the temperature
control is adjustable to provide a range of temperatures for your
personal satisfaction. To adjust the temperature setting, turn the
temperature control knob clockwise or counter clockwise. Allow
several hours for the temperature to stabilize between adjustments.
Electromechanical Control
Figure 1
Standard Electronic Temperature Control (Some
Upright Frost Free Models)
The standard electronic temperature control is located inside the
freezer on upright models (see Figure 2). Temperature is factory
preset to provide satisfactory food storage temperatures. To
adjust the temperature setting, move the UP (A) button for warmer
temperature and DOWN (V) button for colder temperature on the
control panel. Allow several hours for the temperature to stabilize
between adjustments.
0 - ArrOt
@
Standard Electronic Temperature Control
Figure 2
Deluxe Electronic Temperature Control (Some Upright
Frost Free Models)
Refer to the Electronics Control Guide supplied when you purchase
a deluxe electronic upright model. See Figure 3 for deluxe
electronics control panel.
Deluxe Electronic Temperature Control
Figure 3
Freezer Optional Features
Your freezer may have some or all of the features listed below.
Become familiar with these features and their use and care.
Power On Light
The power on light indicates that the freezer is properly connected
to an electrical power. The light glows even when the temperature
control is turned to "OFF". If the light goes out, refer to "Freezer does
not run" in the Avoid Service Checklist section.