Owner's Guide

4
FEATURES AT A GLANCE
Features may vary according to model
Your dishwasher cleans by spraying a mixture of hot water and detergent through the spray arms
against soiled surfaces. First, the dishwasher drains for a few seconds to remove soils dropped while
loading, then fi lls with water covering the fi lter area. Water is then pumped through the spray arms. Soil
particles go through and across the fi lter and down the drain as the water is pumped out. This series of
steps are repeated as needed. The number of water fi lls varies with the cycle being used.
Operating Instructions
Tub Gasket
Middle Spray
Arm
Lower Rack
Cup Shelves
Lower Spray
Arm
Detergent
Dispenser
Rinse Aid
Dispenser
Upper Spray Arm
Upper Rack
Silverware
Basket
Filter
Serial Label
(located on right
side of door)
Soft Grip
Rack
Cutlery Tray
Getting Started
1. Load Dishwasher (See Preparing and Loading
Dishes).
2. Add detergent (See Dishwasher Dispenser &
Detergents).
3. Add Rinse Aid, if needed (See Rinse Aid).
4. Run hot water faucet nearest dishwasher until
water is hot. Turn water off.
5. Select desired CYCLE (See Cycle Chart).
6. Select desired OPTION (See Option
Selections).
7. To start, press START/CANCEL pad and close
door immediately.
To Start a Cycle
When cycle and options are selected, LEDs of
selected cycle and options are illuminated. The
status window displays the cycle time and then
displays ‘Press Start’.
To start the cycle, press START/CANCEL pad and
close the dishwasher door immediately.
The status window displays ‘Close’ after the START/
CANCEL pad is pressed.
A tone will sound indicating the cycle is successfully
started after door is closed.