Use & Care Guide

Assembly of the burner caps

Make sure that all of the surface burner caps and surface

burner grates are installed correctly and at the correct loca

tions.

1. Remove all packing material from the cooktop area.

2. Make sure burner head and caps are properly placed

on the surface burners.

Important: The burner head has a hole which fits over the

ignitor. Make sure the head fits snugly before placing the

burner caps.

Note: Unpack the burner grates and position them on the

cooktop after the burner heads and caps are properly

installed.

On round-style burners, the burner cap lip (Figure 1) should

fit snug into the center of the burner head and rest level.

Refer to

Figure 2 for correct and incorrect burner cap place-

ment.

Figure 2: Proper burner cap placement

Once in place, you may check the fit by gently sliding the

burner cap from side to side (

Figure 3) to be sure it is

centered and firmly seated.

Figure 3: Gently move cap for proper placement

Figure 1: Burner cap (A) burner head (B) ignitor (C)

orifice (D)

• Do not allow spills, food, cleaning agents, or any

other material to enter the gas orifice holder opening.

• Always keep the burner caps and burner heads in

place whenever the surface burners are in use.

• Never place flammable items on the cooktop.

Please note that the burner cap should not move off the

center of the burner head when sliding from side to side.

• Check and be sure that all oval-style burner caps

(some models) are correctly in place on oval burner

heads.

• Do not use the surface burners without the burner

caps and heads properly installed. Improperly seated

burner caps and heads may prevent burners from

lighting or cause uneven flame and heating.

• Missing pieces or improper installation may lead to

spills, burns, or damage to your range and cookware.

• Never place flammable items on the cooktop.

CAUTION

IMPORTANT

BEFORE SETTING SURFACE CONTROLS