Installation Guide

ManualsBrandsFrigidaire ManualsKitchen Appliance PackageFrigidaire Gallery Series FRRERADWMW5165

30” ELECTRIC FRONT CONTROL FREESTANDING INSTALLATION INSTRUCTIONS

Fig. 11

5A. POWER CORD CONNECTIONS

(4-Wire Connection Instructions - Refer

to Fig.12)

Before wiring the range review the suggested power

source location drawing in Fig. 3. If connecting to a 4-Wire

electrical system (new branch-circuit or mobile home

requires 4-Wire connection):

1. Follow the manufacturer’s installation instructions

supplied with the strain relief and install (Also see Figs.

9, 10 & 11).

2. Insert the end connectors for Line 1, Line 2 and

Neutral and tighten securely to the terminal block.

IMPORTANT NOTE: DO NOT LOOSEN the factory

installed nut connections which secure the range

wiring to the terminal block. Electrical failure or loss

of electrical connection may occur if these 3 nuts are

loosened or removed.

3. You must disconnect the ground strap. Remove the

factory installed ground screw & plate to release the

copper ground strap from the frame of the appliance.

Cut and discard the copper ground strap & plate.

KEEP the ground screw.

4. Connect the ground wire (Green) lead with the eyelet

to the frame of the appliance with the ground screw

using the same hole in the frame where the ground

screw was originally installed (See Fig. 12).

5. Make sure all screws are tightened securely and

replace the rear access cover (See Fig. 9).

Fig. 12

NOTE: Internal

white wire not

present on all

models.

5B. POWER CORD CONNECTIONS

(3-Wire Connection Instructions

For existing installations ONLY - Refer

to Fig. 13).

1. Follow the manufacturer’s installation instructions

supplied with the strain relief and install (Also see

Figs. 9, 10 & 11).

2. Insert the end connectors for Line 1, Line 2 and

Neutral and tighten securely to the terminal block (See

Fig. 13).