User Manual

24
Locating the Filters
Yourrefrigeratorisequippedwithwater
lteringsystem.Thewaterltersystemlters
all dispensed drinking water, as well as the
waterusedtoproduceice.Thelterislocated
in the top right rear corner of the fresh food
compartment.
Water Filter
Thewaterlterislocatedatthetoprightside
of the fresh food compartment.
Ordering Replacement Filters
Toorderyourreplacementlters,pleasevisit
our online store at www.frigidaire.com/store,
by calling toll-free at 1-800-599-7569, or by
visiting the dealer where you purchased your
refrigerator. Frigidaire recommends that you
orderextralterswhenyourstinstallyour
refrigerator,andthatyoureplaceyourltersat
least once every six months.
Hereistheproductnumbertorequestwhen
ordering:
PureSource Ultra II
TM
Water Filter
Part #EPTWFU01
Replacing the Water Filter
In general, you should change the water
ltereverysixmonthstoensurethehighest
possiblewaterquality.Water Filter Status
on the user interface prompts you to replace
thelterafterastandardamountofwater
(125 gallons/473 liters for PureSource
Ultra II
TM
) hasowedthroughthesystem.
If your refrigerator has not been used for a period
of time (during moving for example), change the
lterbeforereinstallingtherefrigerator.
Do not use with water that is microbiologically
unsafeorofunknownqualitywithoutadequate
disinfection before or after the system. Systems
certiedforcystreductionmaybeusedon
disinfectedwatersthatmaycontainlterablecysts.
Test & certication results:
• Rated Capacity - 125 gallons/473 liters for
PureSource Ultra II
TM
iceandwaterlter
• Ratedserviceow-.65gallonsperminute
• Operating Temp: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds per
squareinch
• Recommended Minimum Operating
Pressure:30poundspersquareinch
To replace your PureSource Ultra II
TM
water lter:
It is not necessary to turn the water supply off
tochangethelter.Bereadytowipeupany
small amounts of water released during the
lterreplacement.
1 Turn Off the ice maker power switch.
 2 Removetheoldlterbyrotatingitcounter-
clockwise (to the left) 90 degrees to release it.
 3 Slidetheoldltercartridgestraightoutof
the housing and discard it.
 4 Unpackagethenewltercartridge.Slideit
intothelterhousingasfarasitwillgowith
the grip end horizontal.
 5 Pushlightlyinwardonthelterwhilerotating
itclockwise(totheright).Thelterwillthen
pull itself inward as it is rotated. Rotate the
lter90degreesuntilitstopsandthegrip
end is vertical. You may be able to feel a very
lightclickasthelterlocksintoplace.
6 Press a drinking glass against the water
dispenser while checking for any leaks at
thelterhousing.Anyspurtsandsputters
that occur as the system purges air out of
the dispenser system are normal.
7 Continue dispensing water for 3-4 minutes
oruntil1.5gallonsofwaterhasowed
through the system. You will likely need to
emptyandrellyourglassseveraltimes.
8 Turn On the ice maker.
9 Press and hold the Water Filter reset
button on the control panel for three
seconds. When the display changes from
Red to Green, the status has been reset.
The PureSource Ultra II
TM
iceandwaterltersystemis
testedandcertiedtoNSF/ANSI
Standards 42, 53 and 401 for the
reductionofclaimsspeciedon
the performance data sheet.
More about your Advanced
Water Filter

NOTE
Whenorderingyourreplacementlter,
pleasereorderthesameltertypethatis
currently in your refrigerator.
CHANGING THE FILTER
Filter Cartridge