Owner's Manual

31
SETTING OVEN CONTROLS
Setting Self Clean
To set self clean:
1. Be sure the oven is empty and all oven racks are
removed. Remove all items from the oven. Be sure
oven door is completely closed.
2. Press Self Clean.
3. A 3 hour clean time will appear in the display. You may
accept the 3 hour clean time or choose a different clean
duration by entering any time between 2 and 4 hours
clean time by entering the time using the numeric keys.
4. Press OK/START twice to activate self clean.
5. The warning to REMOVE RACKS will flash in the
display and beep for 30 seconds to remind you that
oven racks should be removed before a self clean.
6. The warning will end and Self Clean will start. The
motor door lock will begin locking the oven door.
When the oven is set to run a self-clean cycle, the motor
door lock will begin locking the oven door. Do not open the
oven door while the lock motor is running or when any
locking indicators or displays are showing. The oven door is
completely locked in about 15 seconds. Once the oven door
has locked, CLEAN will appear in the display indicating self
clean has started.
Do not force the oven door open when self-clean is active.
This can damage the automatic door-locking system. Use
caution when opening the door after self-clean cycle is
complete; the oven may still be very hot.
When self clean is finished:
1. CLEAN message will turn off, and Hot will appear in
display window.
2. Once the oven has cooled down (about 1 hour) and Hot
is no longer displayed, the oven door may be opened.
3. When the oven interior has completely cooled, wipe
away any residue or powdered ash with a damp cloth or
paper towel.
Setting Delay Start Self Clean
To start a delay self clean with default clean time of 3
hours and a start time of 9:00 o’clock:
1. Be sure the clock is set with the correct time of day, the
oven is empty, and all oven racks are removed. Be sure
oven door is completely closed.
2. Press Self Clean
3. Press Delay Start.
4. Using numeric keypad, enter 9 0 0.
5. Press OK/START twice to accept.
If it becomes necessary to stop self clean when active:
1. Press OFF.
2. If self clean has heated the oven to a high temperature,
allow enough time for the oven to cool.
3. Before restarting self clean, be sure to read important
notes below.
Important note:
• If your clock is set with the (default) 12 hr display mode,
the delay start for a self clean can only be programmed
to start up to 11 hours and 59 minutes after the time
showing in the display (be sure to set the clock to
current time before programming a Delay Start). To set
a Delay Start self clean to begin 12 or more hours
(maximum is 23 hours and 59 minutes) after the time of
setting, be sure to first set the control in the 24 Hr
display mode.
• If self clean was active and then interrupted by a power
failure or cancelled before the oven was thoroughly
cleaned, it may be necessary to run another self clean
cycle.
• If the oven temperature was high enough when self
clean was interrupted the oven control may not allow
another self clean cycle to be set for up to 4 hours.
To avoid possible burns, use care when opening the oven
door after the self-cleaning cycle. Stand to the side of the
oven when opening the door to allow hot steam and air to
escape.
CAUTION