Owner Manual

WARNING
Make sure the electrical power cord is
unplugged from the wall outlet.
10
DOOR REMOVAL INSTRUCTIONS
NOTE
DO NOT remove the ground screw from
hinge.
2 Disconnect the harness by grasping both
sides of the connector rmly, depress the
latch and pull apart.
Getting through narrow spaces
If your refrigerator will not t through an
entrance area, you can remove the doors.
Check rst by measuring the entrance.
To prepare for removing the doors:
1 Make sure the electrical power cord is
unplugged from the wall outlet.
2 Open the freezer drawer and remove the
toe grille (see Installation section).
3 Remove any food from the door shelves
and close the doors.
To remove the top hinge covers:
1 Remove the two screws from each cover
over the top door hinges.
2 Lift inside edge of hinge cover and tilt
back.
Rear
Cover
Screw
Ground
Screw
Top
Hinge
Top Hinge
Cover
Hinge
Screws
Multi-wire
Cables
Leave
Hinge
With
Door
Cover Screw
Water
Line
Rear
Cover
Screw
Top
Hinge
Ground
Screw
Cover Screw
Top Hinge
Cover
Hinge
Screws
Leave
Hinge
With
Door
To remove the refrigerator doors
1 Remove top hinge covers. Trace lightly
around the door’s top hinges with a pencil.
This makes reinstallation easier.