Owner's Manual

14
SETTING OVEN CONTROLS
Setting the Clock
When the appliance is first powered up, 12:00 will flash in
the display. The time of day must first be set before
operating the oven.
To Set Clock to 1:30:
1. Press .
2. Enter 1 3 0 using numeric keys.
3. Press OK/START.
Important note:
The clock cannot be changed when a Self Clean, Delay
Start, or cooking feature is active.
Setting Timer
The minute timer allows you to track your cooking times
without interfering with the cooking process. The timer may
be set from a minimum time of 1 minute to a maximum of 11
hours and 59 minutes.
To set timer for 5 minutes:
1. Press Timer On-Off.
2. Enter 5 using numeric keypad.
3. Press Timer On-Off to start the timer. When set time
ends, END will show in the display and the control will
sound a beep three times every 30 seconds until Timer
On-Off key is pressed.
To cancel the timer when active, press Timer On-Off again.
Important note:
• The timer does not start or stop the cooking process. It
serves as an extra minute timer that will beep when the
set time has run out. The timer may be used alone or
while using any of the other oven functions.
• When timer is set for more than 1 hour it will display
hours and minutes until 1 hour remains. When less than
1 hour remains, the display counts down in minutes and
seconds. With less than 1 minute remaining, only
seconds will display.
• If the timer is active during a cooking process, the timer
will show in the display. To view the status of any other
active oven function, press the key of the cooking
function once and it will appear in the display for a few
seconds.
Add 1 Min
Use the Add 1 min feature to set additional minutes to the
timer. Each press of the key will add 1 additional minute. If
Add 1 min is pressed when the timer is not active, the timer
will activate and begin counting down from 1 minute.
To add 2 minutes to the timer:
Press Add 1 Min twice.
Setting 12 Hour or 24 Hour display mode
The clock display mode allows you to select 12 hr or 24 hr
modes. The factory pre-set clock display mode is 12 hours.
To set 12 hr or 24 hr display mode:
1. Press and hold for 6 seconds.
2. Press Self Clean to toggle between 12 Hr day or 24 Hr
day display modes (
Figure 5).
3. Press OK/START to accept the choice.
Changing between continuous bake setting or 12 hour
energy saving
The oven control has a factory preset built-in 12 Hour
Energy Saving feature that will turn off the oven if the oven
is left on for more than 12 hours. The control may be
programmed to override this feature to bake continuously.
To change between continuous bake or 12 hour energy
saving feature:
1. Press and hold Timer On-Off for 6 seconds
2. Press Self Clean to toggle between 12 Hour OFF or
Stay On feature (
Figure 6).
3. Press OK/START to accept choice.
Figure 5: 12 Hr dAy and 24 Hr dAy settings
Figure 6: 12 hr energy saving (L) continuous setting (R)