Owner's Manual

29
SETTING OVEN CONTROLS
Restoring Factory Default Settings
Your appliance was set with predetermined (default) oven
control settings. Over time, users may have made changes
to these settings. The following options may have been
modified since the appliance was new:
• 12 or 24 hr display mode
• All Meat Probe settings
• Continuous bake or 12 hour energy savings mode
• Silent or audible control
• Oven temperature display (Fahrenheit or Celsius)
• Oven temperature adjustments (UPO)
To restore oven control to factory default settings:
1. Press and hold 7 on numeric keypad until acceptance tone
sounds (about 6 seconds).
2. Press OK/START. The control has been reset with the default
settings.
Adjusting Oven Temperatures
Your appliance has been factory calibrated and tested to
ensure accurate baking temperatures. For the first few
uses, follow your recipe times and temperature recommen
-
dations carefully. If you think the oven is cooking too hot or
too cool for your recipe times, you may adjust the control so
the oven cooks hotter or cooler than the oven temperature
displayed.
Important: Do not use oven thermometers such as those
found in grocery stores to check the temperature settings
inside your oven. These oven thermometers may vary as
much as 20 to 40°F degrees from actual temperatures.
The oven temperature may be increased as much as +35°F
(+19°C) or decreased -35°F (-19°C) from the factory cali
-
brated settings.
To increase or decrease the oven temperature by 20°F:
1. Press and hold Bake until the control produces an
audible tone (about 6 seconds). The factory offset
temperature of 0
(zero) should appear in the display.
2. Enter 2 0 using numeric keypad.
3. To offset the oven by -20°F, press self clean to toggle
between + and -.
4. Press OK/START to accept change.
Important note:
• Oven temperature adjustments will not change the
Broil, Self Clean, or Keep Warm temperatures.
• The oven temperature adjustment may be made if your
oven control is set to display temperatures in °C
(Celsius). Minimum and maximum settings for Celsius
range from plus (+)19°C to minus (-) 19°C.
All of the above user settings will be restored to the
factory default settings.
CAUTION