Installation guide

Installation Instructions

Leveling your washer

Excessivenoise and vibration can be prevented by properly

leveling the washer.

1. With the washer within 4 feet (1 m) of its final location,

place a level on top of the washer.

2. Use adjustable pliers to adjust the leveling legs so the

washer is level front-to-rear and side-to-side, and stable

corner-to-corner.

3. Pressdown on alternate corners and sides and feel for the

slightest movement. Adjust the appropriate leg(s) so the

washer sits solidly on the floor on ALL four legs. Keep the

leveling leg extension at a minimum for best performance

of the washer.

Connecting inlet water

1. Run some water from the hot and cold faucets to flush the

water lines and remove particles that might clog the water

valve screens and to determine which faucet is hot and

which is cold supply.

2. Remove the inlet hoses and rubber washers from the

plastic bag located in the drum of the washer and install

the rubber washers in each end of the inlet hoses.

RUBBERWASHERS ....\,_ ,,

MUST BEPRESENT

USE ONLY

NEW HOSES

a b

3. Connect the HOT inlet hose to the HOT inlet connection

on the washer and the COLD inlet hose to the COLD

inlet connection on the washer. Tighten by hand until

snug. Then tighten each supply connection another 2/3

turn with pliers. Do not cross thread or over-tighten these

connections.

4. Connect the HOTinlet hose to the HOTwater supply and

the COLD inlet hose to the COLO water supply. Tighten

by hand until snug. Then tighten each supply connection

another 2/3 turn with pliers.

5. Turn on the water and check for leaks.

• /

-",xx xC-