Specs

INSTALLATION SPECIFICATIONS
•
Product Shipping Weight (approx.) – 83 Lbs.
•
Voltage Rating – 120V / 60 Hz / 15 Amps (maximum 20 Amps if connected
with disposer)
•
Connected Load (kW Rating) @ 120 Volts = 1.20kW
(For use on adequately wired 120V, dedicated circuit having 2-wire service
with a separate ground wire. Appliance must be grounded for safe operation.)
•
Amps @ 120V = 10 Amps
•
Always consult local and national electric & plumbing codes. Meets
requirements of ASSE 1006 — integral air gap on supply.
•
Water Pressure – Hot water line to dishwasher must provide between 20 and
120 pounds per square inch (psi) with at least 120° F hot water temperature.
•
Make sure location has correct drain, water and electrical outlets to make
connections — MUST be confined to shaded areas.
•
Electrical and water supplies should enter cabinet opening on floor, or through
back or side walls, as shown in shaded areas.
•
Keep back free of drain, water & electrical supply.
•
Connections preferably located toward left side of dishwasher. Do not cross
drain, water or electrical lines in front of motor, blower or frame.
•
If connecting drain hose to sink trap, local code may require installation of
Air Gap Kit (not included).
•
Leveling legs supplied to adjust height.
•
When installing adjacent to wall, cabinet or other obstruction that extends
beyond front edge of unit, allow 2" minimum clearance between opened door
and obstruction.
•
Floor should be flat and free of obstructions with carpet removed to provide
motor clearance.
•
When installing at end of cabinet line, sides and back must be fully enclosed.
•
Do not install unit under a cooktop, damage will occur.
•
Recommended to seal cabinets, enclosing all sides of dishwasher, including
underside of countertop, with oil-based paint or moisture-proof polyurethane
to prevent possible steam/moisture damage.
24" Built-In Dishwasher with Integrated Controls (IC),
Plastic Tub (PT) & Integrated handle (IH)_Frig Gallery
6"
2
1
/2
"2
1
/2"
4"
18"
24"
min.
Electrical, water,
and drain
lines
must be confined
to shaded
area
6"
24"
7
3
/4"
90° 90°
3
"
34
1
/4"
min.
Hot
water
line
Electrical
wiring
Front
33
1
/2"
Adjustable
to 35"
24"
Power supply location (right bottom front)
49
1
/
4
"
22
1
/2"
RightLeft
25"
Water inlet
(left bottom front)
Door in 90°
open position
FGIP2468UF
DISHWASHER
24" BUILT-IN
Meets
requirements of
ASSE 1006
Specifications subject to change. Accessories information available on the web at frigidaire.com
Note: For planning purposes only. Always consult local and national electric, gas and plumbing codes.
Refer to Product Installation Guide for detailed installation instructions on the web at frigidaire.com.
USA
•
10200 David Taylor Drive
•
Charlotte, NC 28262
•
1-800-FRIGIDAIRE
•
frigidaire.com
CANADA
•
5855 Terry Fox Way
•
Mississauga, ON L5V 3E4
•
1-800-265-8352
•
frigidaire.ca
FGIP2468U 08/18
© 2018 Electrolux Home Products, Inc.