Owner's Manual

INSTALLATION
Proper installation is the responsibility of the installer.
Product failure due to improper installation is not covered under Warranty.
In applications where unit is a replacement, it is recommended that a Frigidaire sleeve be used.
Your product can retrofit General Electric, Amana, Trane, and Friedrich sleeves/grilles (be sure outdoor grille
is installed on the sleeve). See Table 3 for details.
For any sleeve retrofit applications, be sure that the foam seals (factory - installed on the tube sheets)
provide a good seal between the grille and outdoor coil tube sheets. These foam seals provide a barrier that
stops air from the inside mixing with air on the outside (known as air recirculation).
! CAUTION
UNIT DAMAGE AND/OR OPERATION HAZARD
Failure to follow this caution may result in equipment
damage or improper operation.
For retrofit applications, foam seals on outdoor coil
tube sheets must make a seal between the coil and
the grille or loss of performance and premature
damage to the major components can result.
!
CAUTION
Table 3—Retrofit Wall Sleeves
Manufacturer Wall Sleeve Part Number
Metal Sleeve RAB71
General Electric
Plastic Sleeve RAB77
Amana Metal Sleeve WS900B
Trane Metal Sleeve SLV149
T---Series Metal 111/2---in. Deep Wall
Sleeve*
Friedrich
Standard Depth Wall Sleeve
16 X 42 X 133/4---in. PXWS
* FR-SLEEVE-EXT accessory is required for retrofit into Friedrich
(T - Series) wall sleeves.
INDOOR
COIL
DISCHARGE
GRILLE
WIRE SCREEN
OUTDOOR
ORIFICE
COIL TUBE
SHEETS
INDOOR-AIR
INLET
FILTERS
ACCESSORY
WALL
SLEEVE
ACCESSOR
OUTDOOR
GRILLE
Fig. 3 Unit Components
FR ONT
PANEL
BASEPAN
2010 Electrolux Home Products, Inc. All rights reserved.
5
CHASSIS INSTALLATION
1.Remove shipping tape if they are applied.
2.Remove front panel. See Fig.10.
3.
Unscrew four screws which connect the main unit with sleeve. The screws location can be referred to Fig.11.
4.Pull out the unit from the wall sleeves.
5.Install sleeve into the wall (please see Installation Instructions of PTAC Sleeve for details).
Note: We recommend always to use a Frigidaire sleeve.
When units are shipped with a sleeve:
When units are shipped without a sleeve: