Owner's Manual

INSTALLATION

RETROFIT SLEEVE PREPARATION

IMPORTANT: Inspect wall sleeve thoroughly prior to installation. Manufacturer does not

assume responsibility for costs or damages due to defects in sleeve or for improper installation.

! WARNING

ELECTRICAL SHOCK HAZARD

Failure to follow this warning could result in personal injury or death.

Disconnect all power to unit to avoid possible electrical shock during

installation.

WARNING

Remove any existing foam baffles that are installed on competitive outdoor grille, if present. See Fig. 4.

GE Sleeves Only

GE Metal Wall Sleeve - GE metal sleeve is interchangeable with Frigidaire wall sleeve. See Fig. 5.

GE Plastic Sleeve - Remove bottom seal from plastic sleeve. See Fig. 6.

INSTALLATION OF A FRIGIDAIRE WALL

SLEEVE USING A NON- FRIGIDAIRE GRILLE

Using a Frigidaire wall sleeve with a non-Frigidaire grille requires installation of an Accessory Baffle Kit

(see Fig. 7), which ensures a good seal between the unit and exterior grille to prevent air recirculation. Air

recirculation is a large contributor to performance loss and premature damage to major components.

Notes: Frigidaire stamped grille is interchangeable with GE'S.

Fig.4–Remove Existing Outdoor Grille

Baffles on Competitive Grille

BAFFLES

Fig.5-GE Metal Sleeve

Fig. 6 – Remove Bottom Seal From GE Plastic Sleeve

SLEEVE

BOTTOM SEAL

Fig. 7–Accessory Baffle Kit

Note: Contact your units supplier to get the kit, the actual baffle

kit may look different from the image shown above.