Owner's Manual

INSTALLATION

INSTALLATION OF A FRIGIDAIRE PTAC INTO A FRIGIDAIRE WALL SLEEVE

1. Carefully remove shipping tape from the front panel and vent door. See Fig. 8.

2. Remove shipping screw from the vent door, if present. See Fig. 9.

3. Remove front panel. See Fig. 10.

4. Lift unit level and slide unit into wall sleeve until foam seal rests firmly against front of wall sleeve.

5. Secure with four screws (supplied) through the unit flange holes. See Fig. 11.

6. Reinstall front panel. See Fig. 12.

! CAUTION

UNIT DAMAGE HAZARD

Failure to follow this caution may result in equipment

damage or improper operation.

Failure to remove shipping tape and screw will prevent

fresh air vent door from opening and may result in

damage to vent door cable

CAUTION

Fig. 8 – Shipping Tape Location

Shipping

tape

Fig. 9 – Shipping Screw Location

Remove shipping

screw if present

Pull out at the bottom to release it from the tabs

(1). Then lift up (2).

Fig. 10 – Removing Front Panel

Fig. 11 – Securing Unit

Place tabs over top rail (1). Push Inward at

bottom until panel snaps into place (2).

Fig. 12 – Replacing Front Panel