Manual

Operating Instructions
(continued)
TO OPERATE ON FAN ONLY:
heat
dean m cool remote
air _aCOnnly sensing
temp/timer
timer MODE V 0N-0FF A
DO THIS:
PRESS
MODE BUTTON
CHOOSE
FAN ONLY
YOU WILL SEE=
i heat
dean cool remote
econ sensing
air [] fan on_
temp/timer
F
timer MODE V 0N-0FF A
Note: Use this function only when cooling is not desired,
such as for room air circulation or to exhaust stale air on
some models. (Remember to open the vent during this
function, but keep it closed during cooling for maximum
cooling efficiency.) You can choose any fan speed you
prefer. (Except "Auto Fan").
During this function, the display will show the actual room
temperature, not the set temperature as in the cooling
mode.
TO USE THE ENERGY SAVER (ECON) FEATURE:
heat
dean cool remote
econ sensing
air [] fanonly
temp/timer
m
timer MODE V ON-OFF A
DO THIS;
PRESS
MODE BUTTON
CHOOSE ECON
YOU WILL SEE:
heat
dean coo! remote
air [] econ sensing
#n on_
temp/timer
m
timer MODE V ON-OFF A
Note: In this mode, the fan will continue to run for 1 minu-
te after the compressor shuts off. The fan then cycles on
for 20 seconds at 10 minute intervals until the room tempe-
rature is above the set temperature, at which time the com-
pressor turns back on.
SLEEP FEATURE: YOU WILL SEE:
temp/timer l
m auto
remote hi []
sensing reed
lo
V ON-OFF A FAN SPEED
fi[ter
reset
steep
DO THIS:
PRESS
SLEEP BUTTON
remote
sensing
temp/timer
F
m
auto J
hi m
med
lo
V ON-OFF A FAN SPEED
fitter
reset
m
s[eep
Note: In this mode the selected temperature will increase
by 2 °F 30 minutes after the mode is selected. The tempe-
rature will then increase by another 2 °F after an additional
30 minutes. This new temperature will be maintained for 7
hours before it returns to the originally selected tempera-
ture. This ends the "Sleep" mode and the unit will continue
to operate as originally programmed. The "Sleep" mode
program can be cancelled at any time during operation by
again pressing the "Sleep" button.
02009 Electrolux Home Products, Inc. All rights reserved.