Manual

Operating Instructions
(continued)
REMOTE SENSING FEATURE
(on some models):
, \ ,s
<IN,
© © ©
remote sensing
L DO THIS;
PRESS REMOTE
SENSING
START BUTTON
dean
air
LIGHT pulsing ( On & Off intermittently ).
L
cool remote F
econ sensing
San only
m
timer MODE V ON-0FF A
NOTE: Unit display shows the set temperature
....C_too I
NOTE: Remote display
is actual temperature
Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode. at remote control only
To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing Start button. Next, use
the" /%V "buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit
itself ). The LIGHT on the unit control wilt pulse to indicate it received the signal. The LIGHT on the remote control will pulse each time it
sends a signal. It will periodically send this signal until the feature is deactivated by pressing the remote sensing Stop button. If the unit
does not receive the remote sensing signal during any 3 minute interval, the unit will beep to indicate the remote sensing mode has
ended. The display on the remote control indicates the temperature at the remote ONLY.
NOTE: The Remote Sensing function is terminated either by using the Remote Sensing Stop button or the main ON/OFF button on the
unit.
FAULT CODES:
remote
sensing
temp/timer
auto [] I
hi fitter
med
lo reset
V 0N-0FF A FAN SPEED steep
remote
sensing
temp/timer
auto [] J
medhi fi[ter
lo reset
V ON-0FF A FAN SPEED steep
Ifthe display reads "AS", a sensor has failed. Contact your
Authorized Frigidaire Service Center.
If the display reads "ES", a sensor has failed. Contact your
Authorized Frigidaire Service Center.
TO CHANGE TEMPERATURE DISPLAY:
temp/timer
auto l
hi _ fitter
med
lo reset
remote
sensing
m
V ON=OFF A FAN SPEED steep
" /DO THIS:
PRESSAND HOLD THE
UP/DOWN BUTTONS
TOGETHER FOR 3 SECONDS
YOU WILL SEE;
remote
sensing
temp/timer
auto
hi, fitter
med
Io reset
V ON-OFF A FAN SPEED steep
Note: The control is capable of displaying temperature in
degrees Fahrenheit or degrees Celsius.
@2009 Electrolux Home Products, Inc. All rights reserved.