Complete Owner's Guide h

Operating Instructions

(continued)

CHECK FILTER FEATURE, YOU WILL SEE:

DO THIS:

PRESS FILTER

RESET BUTTON

TIMER: DELAY STOP / START FEATURE YOU WILL SEE HOW MUCH TIME IS CHOSEN:

FIRST

DO THIS:

PRESS

TIMER BUTTON

THEN

DO THIS:

PRESS

UP/DOWN BUTTONS

Note: This feature is a reminder to clean the Air Filter (See

Care and Cleaning) for more efficient operation. The LED

(light) will illuminate after 250 hours of operation. To reset

after cleaning the filter, press the "Filter Reset" button and

the light will go off.

Note: For Delay Stop, the unit must be in the On position．

Note: For Delay Start, the unit must be in the Off position.

First, Press TIMER button, then adjust timer setting, tap or hold the UP arrow ( ) or the DOWN arrow ( ) to change delay

timer at 0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control will count down the time

remaining until start (8, 7.5, 7, etc.). The Delay Start Operation automatically selects cooling with maximum Fan speed (if Cool,

Energy Saver, or Fan Only was the last mode selected) . The temperature maintained will be the same as previously set. To change

the set temperature, press "COOL" then Up or Down arrows until the desired temperature is indicated on the display. After 5

seconds, the control will automatically change the display back to the hours remaining until the unit will start/stop. Pressing the

unit On/Off button at any time will cancel the Delay Start/Stop function. The Delay Start/Stop Feature will work until the unit either

starts or stops. Once that happens the above steps have to be repeated again.

CLEAN AIR FEATURE(on some models):

Note: When this feature is "ON", the electronic air purifier is

energized to remove pollen and impurities from the air. To

cancel this feature, press the Clean Air button (the LIGHT

will turn off).

Note: This feature can be activated on the unit touch pad

ONLY.

DO THIS:

PRESS

CLEAN AIR

BUTTON