Manual

Operating Instructions
(continued)
FAULT CODES:
auto
m hi
med
lo
m heat
cool
energy saver
ian on_
temp/timer
remote
senstng
auto
[] hi
med
lo
m heat
cool
energy saver
fan on_
temp/timer
remote
_ensmg
auto
[] hi
med
lo
m heat
COOl
energy saver
fanonly
temp/timer
rem£_e
sensmg
If the display reads "HS", a sensor has If the display reads "AS", a sensor has
failed. Contact your Authorized Frigidaire failed. Contact your Authorized Frigidaire
Service Center. Service Center.
TO CHANGE TEMPERATURE DISPLAY:
temp/dmer
DO THIS;
PRESSAND HOLD THE
UP/DOWN BUTTONS
TOGETHER FOR 3 SECONDS
If the display reads "ES", a sensor has
failed. Contact your Authorized Frigidaire
Service Center.
YOU WILL SEE:
temp/timer
Note: The control is capable of displaying temperature in degrees Fahrenheit or degrees Celsius.
TO TURN UNIT OFF: YOU WILL SEE:
temp/timer
DO THIS;
PRESS
ON/OFF BUTTON
temp/timer
mm£te
sensmg
Note: When unit is shut off in the Heat Node, the fan will continue to run for a few seconds to dissipate residual heat within the unit.
ADDITIONAL THINGS YOU SHOULD KNOW
Now that you have mastered the operating procedure, here are more features in your control that you should become familiar with.
Z_ [] The "Cool" circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. /_k
This prevents overheating of the compressor and possible circuit breaker tripping. The fan will continue
\
to run during this time.
• There is a 2-Second delay for the compressor shutting down when selecting FAN ONLY/HEAT. This is to cover the possibility of
having to roll through to select another mode.
, The control will maintain the set temperature within 2 degrees Fahrenheit, between 60F and 90F degrees (in cool mode), 55F
and 80F degrees (in heat mode).
• After a power outage, the unit will memorize the last setting and return the unit to the same setting once power is restored.
©2009 Electrolux Home Products, Inc. All rights reserved.