Manual

ManualsBrandsFrigidaire ManualsRoom air conditionerOfficial Frigidaire room air conditioner

DO THIS:

PRESS FILTER

RESET BUTTON

YOU WILL SEE;

temp/timer

Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. The LED (light) Will

illuminate after 250 hours of operation. To reset after cleaning the filter, press the "Filter Reset" button and the light will go off.

REMOTE SENSING FEATURE

(on some models):

\, /

/_ DO THIS:

I PRESS REMOTE

SENSING

START BUTTON

LIGHT pulsing ( On & Off intermittently ).

temp/timer

rem£te

sensmg

NOTE: Unit display shows the set temperature

NOTE: Remote display

is actual temperature

at remote control only

Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode.

To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing Start button. Next, use

the" A V "buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit

itself ). The LIGHT on the unit control wilt pulse to indicate it received the signal. The LIGHT on the remote control will pulse each time it

sends a signal. It will periodically send this signal until the feature is deactivated by pressing the remote sensing Stop button. If the unit

does not receive the remote sensing signal during any 3 minute interval, the unit will beep to indicate the remote sensing mode has

ended. The display on the remote control indicates the temperature at the remote ONLY.

NOTE: The Remote Sensing function is terminated either by using the Remote Sensing Stop button or the main ON/OFF button on the

unit.

HEATING FEATURE(on some models).

tamp/timer

auto

m hi

mad

heat

m COOl

energy saver

DO THIS:

PRESS

i MODE BUTTON

SELECT H EAT

YOU WILL SEE:

_mp/timer

auto

[] hi

reed

m heat

COOl

energy saver

f_non_

Note: This feature can be used with any combination of FAN Speeds (Low speed only on 115V models), Timer, or Sleep Modes. When in

the "Heat" mode,the fan will run continuously while heat is needed. The temperature wilt automatically be maintained anywhere between

55 °F(13 °C) and 80 °F(27 °C). When the room set temperature is satisfied, the fan will cycle off and on to circulate and sample the room

air.