Complete Owner's Guide

15
FACTORS AFFECTING PERFORMANCE
Water Pressure
The hot water line to dishwasher must provide
water pressure between 20 and 120 psi.
Low water pressure may occur when laundry
or showers are in operation. If you experience
poor wash performance you may need to wait
until water use is reduced before starting the
dishwasher.
Water Temperature
Hot water is needed for best dishwashing and
drying results. Water entering dishwasher should
be at least 120°F (49°C) to give satisfactory
results.
To check water temperature entering dishwasher:
• Turn on hot water faucet nearest dishwasher
for several minutes to clear cool water from
pipes.
• Hold a candy or meat thermometer in the
water stream to check the temperature.
• If temperature is below 120°F (49°C), have
a qualied person raise the hot water heater
thermostat setting.

NOTE
Deselecting the AIR DRY option in combination
with rinse aid will enhance drying performance.
The energy required to not use the AIR DRY
option costs pennies per cycle. You may choose
to select the AIR DRY option; however you
will have items in your dish load that will not be
completely dry at the end of the cycle.
How to adjust the rinse aid dosage
Press and hold the RINSE ONLY pad for 5
seconds until the status window shows rinse aid
level. Pressing the DELAY TIME pad increases
the increment level (L1 - L4).
Once the rinse-aid level reaches L4, the status
window will start back at level L1.
Pressing the START/CANCEL button or just
pausing for a few seconds conrms the rinse
aid level setting: the status window shows the
duration of the cycle.
IMPORTANT
Before starting a cycle, run hot water to clear
cool water from pipe.
Rinse Aid
Rinse aid greatly improves drying, reduces
water spots, lming. With it water “sheets” o
dishes rather than forming water droplets that
cling and leave spots.
A dispenser, located next to the detergent cup,
automatically releases a measured amount of
rinse aid during the last rinse. If spotting and poor
drying are problems, increase the amount of rinse
aid dispensed. The indicator will be dark when full
and will show clear when it is time to rell.
To add liquid rinse aid:
1. Lift up the rinse aid cover to open.
2. Fill the rinse aid dispenser with liquid rinse aid
until the liquid reaches the indicated ll level.
DO NOT overll.
3. Press the rinse aid cover down rmly to close.
4. Wipe up any spills with a damp cloth.
Indicator
Rinse Aid
Compartment
Rinse Aid
Cover
The dispenser holds enough for 11 to 66 washes,
depending on setting.