Use and Care Manual

28
CARE & CLEANING
Care and cleaning tips
Part Cleaning Agents Tips and Precautions
Interior &
Door Liners
•Soap and water
•Baking soda and
water
•Use two tablespoons of baking soda in one quart of warm water.
•Be sure to wring excess water out of sponge or cloth before cleaning
around controls, light bulb or any electrical part.
Door
Gaskets
•Soap and water •Wipe gaskets with a clean soft cloth.
Drawers &
Bins
•Soap and water •Use a soft cloth to clean drawer runners and tracks.
•Do not wash any removable items (bins, drawers, etc.) in dishwasher.
Glass
Shelves
•Soap and water
•Glass cleaner
•Mild liquid sprays
•Allow glass to warm to room temperature before immersing in warm water.
Toe Grille •Soap and water
•Mild liquid sprays
•Vacuum
•Remove toe grille (see Installation Instructions).
•Vacuum both sides and wipe with sudsy cloth or sponge. Rinse and dry.
Exterior &
Handles
•Soap and water
•Non abrasive glass
cleaner
•Do not use commercial household cleaners containing ammonia, bleach or
alcohol to clean handles.
•Use a soft cloth to clean smooth handles.
•Do not use a dry cloth to clean smooth doors.
Exterior &
Handles
(Stainless
Steel Models
Only)
•Soap and water
•Stainless steel
cleaners
•Never use CHLORIDE or cleaners with bleach to clean stainless steel.
•Clean stainless steel front and handles with non-abrasive soapy water and
a dishcloth. Rinse with clean water and a soft cloth.
•Use a non-abrasive stainless steel cleaner. These cleaners can be
purchased at most home improvement or major department stores. Always
follow manufacturer’s instruction. Do not use household cleaners containing
ammonia or bleach.
NOTE: Always clean, wipe and dry with grain to prevent scratching.
•Wash the rest of the cabinet with warm water and mild liquid detergent.
Rinse well and wipe dry with a clean soft cloth.
Ice Chute Extension
(select models)
The ice chute extension is
designed to better direct
iceowintocontainers.
Removing the Ice
Chute Extension
For Cleaning
1 Turn the refrigerator
off using the button
on the control
panel (refer to the
“Controls” section of
this Manual).
2 Pressinwardrmly
on the front of the
chute and pull down.
3 Turn your
refrigerator back on.
Push Upward Until the
Extension Snaps In Place
Pull Down
Press Here
Firmly
Installing the Ice
Chute Extension
1 Turn the refrigerator off
using the button on the
control panel (refer to
the “Controls” section of
this Manual).
2 Align the extension with
the ice chute so that the
snap clips are just inside
the front edge of the chute.
3 Push upward until the extension snaps into place.
4 Turn your refrigerator back on.