Gas Installation

4
30" GAS RANGE INSTALLATION INSTRUCTIONS
Normal Installation Steps
1
Anti-tip Bracket Installation
Instructions Important Safety Warning
To reduce the risk of tipping of the range, the range must
be secured to the oor by the properly installed anti-tip
bracket and screws packed with the range. Failure to
install the anti-tip bracket will allow the range to tip over if
excessive weight is placed on an open door or if child climbs
upon it. Serious injury might result from spilled hot liquids
or from the range itself.
If range is ever moved to a different location, the anti-
tip brackets must also be moved and installed with the
range.
Instructions are provided for installation in wood or
cement oor. When fastening to oor, be sure that
screws do not penetrate electrical wiring or plumbing.
A. Locate the Bracket Using the Template - Locate
the bracket position (right or left side) by placing the
template symmetrically to the center of the nal range
position. Mark the location of the screw holes, shown on
template.
B. Drill Pilot Holes and Fasten Bracket - Drill a 1/8"
pilot hole where screws are to be located. If bracket is to
be mounted to the wall, drill pilot hole at an approximate
20° downward angle. If bracket is to be mounted to
masonry or ceramic oors, drill a 3/16" pilot hole 1-3/4"
deep. The screws provided may be used in wood or
concrete material. Use a 5/16" nut-driver or at head
screwdriver to secure the bracket in place.
Figure 1
Figure 2
FASTEN BRACKET (WALL OR FLOOR MOUNTING)
FASTEN BRACKET (FLOOR MOUNTING ONLY)
Leveling leg
Wall mount
Floor Mount
Anti-Tip Bracket
Rear of Range
1-1/4” Max.
Wall Plate
Wall
More than
1-1/4”
Leveling leg
Floor Mount
Anti-Tip Bracket
Rear of Range