Manual

22
SETTING OVEN CONTROLS
Adjusting the Oven Temperature
The temperature in the oven is pre-set at the factory. When
first using the oven, be sure to follow recipe times and
temperatures.
If you think the oven is cooking too hot or too cool for the
temperature you select, you can adjust the actual oven
temperature to be more or less than what is displayed by
accessing the UPO (User Programmable Offset).
Before adjusting, test a recipe by using a temperature
setting higher or lower than the recommended temperature.
The baking results should help you to decide how much of
an adjustment is needed.
Important: Before making a temperature adjustment, make
sure both the oven mode and oven temperature control
knobs are in the OFF position.
To adjust the oven temperature:
1. When the oven is idle, press and hold both the light icon
and the clock icon at the same time for a few seconds
until the display sounds an acceptance chime. AUd
should appear in the display.
2. Press the + key in the upper part of the display until
UPO appears and the default setting of
0° (or the last
offset temperature) is showing.
3. Using the + or - key in the bottom of the display, press
until the desired temperature change (offset) is
reached. The display will change
± 5° with each key
press to a maximum of
+ 35° or a minimum of – 35°F.
If a lower temperature offset is desired, press the – key in
the bottom of the display until the desired lower tempera
-
ture appears.
4. Release the key and the control will accept the change.
5. To return the display to normal, press and hold both the
oven light icon and the clock icon at the same time
until an acceptance chime sounds. The display will
return to show the time of day.
Restoring Factory Control Settings
Your appliance was set with standard oven control settings.
Over time these may have been changed. Restoring the
control to factory (default) settings will affect the following:
• Continuous bake or 6 hour energy saving
• Silent or audible control
• Oven temperature adjustments
To restore oven control to default settings:
1. When the oven is idle, press and hold both the light icon
and the clock icon at the same time for a few seconds
until the display sounds an acceptance chime. AUd
should appear in the display.
2. Press the + key in the upper part of the display until rSt
appears and yes or no appears in the lower part of the
display.
3. Press the + or - key to toggle between yes (to reset to
default) or no (to leave current settings as they are).
4. When the desired setting appears, the control will
accept the change after a few seconds with a beep and
return to the clock mode.
Do not use oven thermometers such as those found in
grocery stores to check the temperature settings inside
your oven. These oven thermometers may vary as much
as 20 to 40 degrees from actual temperatures.
Figure 16: UPO shown at default setting
Figure 17: UPO shown 10° higher than default
NOTE
Figure 18: UPO shown 10° lower than default
Changing the UPO will not affect the broil or self clean
temperatures.
NOTE