Range User's Manual

43
Solutions to common problems • BEFORE YOU CALL
Oven portion of
appliance does not
operate.
Problem Possible Causes Solutions
Be sure the oven control was set correctly for the requested
feature. See Setting Oven Controls section and review
instructions for the desired cooking function in this manual or see
"Entire appliance does not operate" in this checklist.
Entire appliance does
not operate.
Be sure appliance power cord is plugged properly to electrical
outlet. Check house circuit breaker; reset if needed. If the electric
service to the house is out, call your local electric utility for
service.
Incorrect oven control setting.
Power supply to appliance
disconnected or electrical
power outage.
Contact your dealer, installing agent or authorized service agent
for assistance.
Service wiring is incomplete.
Cannot move
appliance easily.
Appliance must be
accessible for
service.
Range is not level.
To correct, place oven rack in center of oven. Place a bubble (or
spirit) level centered on the oven rack. Adjust by turning leveling
legs at bottom of range until the oven rack rests level.
Convect fan turns ON
and OFF while cooking
(some models).
The convect fan will turn OFF if the oven door is opened while any
convect feature is active. Close oven door.
Convect fan turns on
with features that
should run without a
fan (some models).
For some models the convect
fan may turn ON while
preheating.
Oven control displays
"Prob ERR". The
probe is not
recognized by the
oven control (some
models).
If the error code persists, the
probe may be damaged or the
probe cable has a short.
Floor is not level, weak or
unstable.
If floor under range is sagging or sloping, contact a carpenter to
correct the problem.
The cooktop or oven racks are
not level.
Be sure kitchen cabinets are square & have sufficient room for
appliance clearance.
Cabinet alignment may make
range appear not level.
Contact builder or installer to make appliance accessible.
Carpet interferes with range. Provide sufficient space so appliance may be lifted over carpet.
Cabinets are built in too tightly
to appliance sides.
Oven door is open.
This is normal (some models).
Convect fan makes
noise (some models).
The convect fan may turn ON
or OFF automatically.
This is normal. On some cooking features the convect fan may run
until the feature is done or the door was opened or closed.
The probe is not fully inserted
into the probe receptacle.
Double check that the temp probe is fully inserted into probe
receptacle. Use only the probe originally supplied with range.
Remove the probe from receptacle and oven. The oven may still
be used normally without the probe. Call your authorized service
agent for a replacement probe.
Lock feature may be active. Cancel the lock feature (some models).