Installation guide

OverheadCabinetShouldNotExceed
a MaximumDepthof 13"(33cm)
30" (76.2cm)Min.
ClearanceBetweenthe
TopoftheCooking
PlatformandtheBottom
of anUnprotectedWood
orMetalCabinet _,A
|
24" (61 cm)Min.
when Bottom of Wood
or Metal Cabinet
is Protected by Not
LessThan 1/8" Flame
Retardant Millboard
Covered With Not Less
Than No. 28 MGS Sheet
Steel, 0.015" (0.4 mm)
Stainless Steel, 0.024"
(0.6 mm) Aluminum or
0.020" (0.5 mm) Copper
18"
(45.7 cm)
G
F
Approximate Location
of Junction Box
2 1/2" (6.4 cm) Min. :rom
Edge of Cutout to Front Edge
of Countertop
Letters on this figure refer to chart on front page exceptfor ] & K.
12"
(30.5 cm)
] Min. From
Edge of
Cooktop
to Nearest
Combustible
Wall (Either
Side of Unit).
For a drawer installation
below the cooktop, allow
8" (20.4cm) of clearance
underneath the countertop.
The drawer must not interfere
with the electrical installation
of the cooktop or contain
flammable materials.
To eliminate the risk of burns
or fire resulting from reaching over heated
surfaces, cabinet storage space located
above the cooktop should be avoided. If
cabinet storage is provided, risk can be
reduced by installing a range hood that
projects horizontally a minimum of 5" (12.7
cm) beyond the bottom of the cabinets.
30" CeramicGlass
36" CeramicGlass
7 ½" (19.1cm)
7 ½" (19.1cm)
2" (5.1cm)
2" (5.1cm)
Figure 2 - COUNTERTOP CUTOUT OPENING
2