Installation guide

Installation Instructions
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST (cont.)
_ Rotate blower unit counterclockwise 180 °.
BeforeRotation After Rotation
Microwave Microwave
[]Gently tim wires fl'om tile
renlove
grooves.
Reroute the wires through grooves on other side
of the blower unit.
BeforeRerouting After Rerouting
Wires RoutedThroughRightSide Wires RoutedThroughLeft Side
[]Roll the blower unit 90 ° so that fan blade
openings are facing out the back of the
nlicrowave.
BeforeRolling
Backof
Microwave
After Rolling
Microwave
[]Place the blower unit back iirto the opening.
End
CAUTION: Do not pull or stretch the blower
unit wiring. Make sure the wires are not
pinched, and that they are properly secured.
NOTE: The blower unit exhaust
openings should match exhaust
openings on rear of microwave oven.
] Secure tim blower unit to tim microwave with
tim original screw.
2_,er Plate Backof
Microwave
[]Replace the blower [)late in the same position
as before with the screw. Make sure the screw
is tight.
[] Attach the exhaust adaptor to the rear of the
oven by sliding it iirto the guides at the top
center of the back of the oven.
Adaptor
Backof
Microwave
Guide
!ck,lgTabs
Guide
Push in securely until it is in the lower locking
tabs. Take care to assure that the damper hinge
is installed so that it is at the top and that the
damper swings fl'eely.
17