Installation guide

mnsta ation
4 HOOD EXHAUST DUCT
When the hood is vented to the outside, a hood exhaust duct is
required. AII ductwork must be metaI; absolutely do not use
pIastic duct. Check that all connections are made securely.
Please read the foilowing carefully:
Exhaust sonneetiom The hood exhaust has been designed to
connect to a standard 3-1/4" X 10" rectangular duct. If round
duct is required, a rectanguIar-to-round adapter must be used.
Rear exhaust: If a rear or horizontal exhaust is to be used, care
should be taken to align the exhaust with the space between the
studs, or waII should be prepared at the time it is constructed by
leaving enough space between wall studs to accommodate
exhaust.
Maximum duet length: For satisfactory air movement, the total
duct length of 3-1/4" X 10" rectangular or 6" diameter round duct
should not exceed 140 feet.
Elbows, adapters, walI caps, roof caps, etc. present additional
resistance to air flow and are equivalent to a section of straight
duct which is Ionger than their actual physical size. When caIcu-
lating the total length, add the equivalent lengths of all transi-
tions and adapters plus the length of all straight duct sections.
Figure 3 shows the approximate feet of equivalent length of
some typical ductwork parts. Use the values in parentheses for
calculating air flow resistance equivalent, which should totaI
less than 140 feet.
90° ELBOW (10 FT,)
90° ELBOW (25 FT.)
45_ ELBOW (5 FT,)
45° ELBOW (5 FT.)
ADAPTOR (5 FT,)
WALL CAP (40 FT.)
10"WIDE ELBOW (t0 FT,)
ROOF CAP (24 FT.)
Figure 3
5 TOOLS RECOMMENDED FOR
Phillips Screwdriver • Protective Drop Cloth for
Electric Drill product and range -
you may also use carton
1/2", 5/8" and 3/32" Drill for protection
Bits
• Scissors
1-1/2" Wood Bit or Metal
Hole Cutter • Pencil
(if metal cabinet is used) • Measure
Saw to cut exhaust • Tape
opening (if needed)
6 INSTALLATION HARDWARE
The INSTALLATION HARDWARE items (_ - _) are packed
in a small bag. Items _- @ are packed separately. AII items
are in a small carton packed below the oven.
_tem Name Quantity
___ WoodScrew5 X 30 mm 6
ToggleB01twithnuts 4
(_) SopCabinetScrew5 X 60mm 2
PowerCord Hanger 1
TappingScrew4 x 12mm 3
FlatWasher30mm diameter 2
Grommet 1
RearCushion 1
ExhaustDamperAssembly 1
ScalePlate 2
GreaseFilter 2
_'_U_e with metal cabinets. Surround
@ _he power cord opening. Cut to fit.
®
® @ @
!o IIIItt
Figure 4
Parts shown not to common scale.