Installation guide

Installation Instructions

ALIGNING THE WALL PLATE

CAUTION: Wear gloves

to avoid cutting fingers on

sharp edges.

j_,,_ Draw a Vertical

i Line on Wall _I

I from Center of ,:1

Centerline i Top Cabinet t!t

Notches i I_I

-_? o o ? o o cF--o---_o c _ o o Or---o-_o o o_

I ,

Hole C Area E

\ Hole D

[]Draw a vertical line on the wall at the center of the

30" (76.2 cm) wide space.

[]Use the mounting plate as the template for the rear

wall. Place the mounting plate on the wall, making

sure that the tabs are touching the bottom of the

cabinet or the level line drawn in Step C for cabinets

with front overhang. Line up the notch and centerline

on the bottom of the mounting plate to the centerline

on the wall.

[]While holding the mounting plate with one hand,

draw circles on the wall at holes A, B, C and D

(see illustration above/actual plate marked with

arrows). Four holes must be used for mounting.

NOTE: If neither C nor D is in a stud, find a stud

somewhere in area E and draw a fifth circle to line up

with the stud. It is important to use at least one wood

screw mounted firmly in a stud to support the weight

of the microwave.

Set the mounting plate aside.

Drill holes on the circles. If there is a stud, drill a sad'

hole for wood screws. For holes that don't line up with

a stud, drill a 5/_,, hole for toggle bolts.

NOTE: DO NOT MOUNT THE PLATE AT

THIS TIME.