Complete Owner's Guide

14
Replacescrewinthelter
retainer.
Tocleangreaselter,soak
 theltersinhotwaterusing
a mild detergent. Rinse well
and shake to dry. Or place
in upper rack of dishwasher
to clean.
NOTE: Do not use ammo-
nia.Thealuminumonthegreaselterwillcorrodeand
darken.
NOTE: You can use either dishwasher or hot detergent
solution and rinse in clean water.
NOTE
The grease lter is dishwasher safe.
To avoid grease lter damage while cleaning,
place lter into the dishwasher top rack for
cleaning
Replacing the Incandescent LightBulb
Turn off the range hood and allow the light bulb to cool.
Disconnectpower-Turnoffhousebreakeratbreakerbox.
Squeeze the plastic lens cover and remove it from the hood.
Screw a 75Wmax,120V
incandescent light bulb
into socket.
Replace lens cover by
squeezing cover and
inserting tabs into
slots.
Reconnect power.
If new light does not operate, make sure the lamp is
inserted correctly before calling service.
Charcoal / Grease Filter Accesory Kit
Forrecirculatingventhood,anoptionalcharcoallteris
available. You can order this as part number 5304486302.
Thecharcoallterisnotwashable.Itshouldlastupto6
months with normal use.
Replacetheoldcharcoallterwithanewcharcoallter.
4.
5.
1.
2.
3.
4.
5.
6.
A
A. Filter screw
RANGE HOOD CARE
A
B
A. Light bulb socket
B. Lens cover
Cleaning
WARNING
To Reduce The Risk Of Fire Or Electrical shock
disconnect from power supply before cleaning.
IMPORTANT
Clean the hood and grease lters frequently
according to the following instructions. Replace
grease lter before operating hood.
IMPORTANT
Exterior Surfaces
Donotusesoap-lledscouringpads,abrasivecleaners,
Cooktop Polishing Creme, steel wool, gritty washcloths
or paper towels.
To avoid damage to the stainless steel, do not use
cleaners that contain chlorine.
Cleaning Method:
Use warm water with liquid detergent or all purpose
cleaner and soft cloth to clean outside surfaces.
Rinse with clean water and dry with soft, lint-free cloth.
Useglasscleanertoremovengerprints.
Forstainlesssteelnishrubindirectionofgrainto 
avoid scratching or damaging the surface.
NOTE: Onstainlesssteelnish,cleanindirectionof
stainless steel brush to avoid scratching or damaging
the surface.
To clean or replace grease lter:
Removescrewfromtheplasticlterretainerclipwith
phillips screwdriver
Turnthelterretainertoreleaselter.
Reinstallthelterbyplacingthebackedgeinthe
 channelatrearofhood.Pushlterintoplace,turn
 thelterretainertosecureltertorangehood.
•
•
•
•
1.
2.
3.
A
A. Filter screw