User Manual
15
BEFORE YOU CALL (Solutions to Common Problems)
OCCURRENCE POSSIBLE CAUSE/SOLUTION
Telescoping Vent
does not fully raise
Check for and remove obstructions. The telescoping vent is designed to tilt and stop with
obstructions. The raise/lower push button will reverse direction of travel and reset the
telescoping vent travel. Allow the telescoping vent to fully raise or lower after encountering
an obstruction.
If the telescoping vent does not respond to the raise/lower push button, it can be
straightened or helped along by hand and the switch should be tried again.
DO NOT attempt to lubricate the telescoping vent. It is factory lubricated for life.
Blower does not turn
on
Make sure telescoping vent is in the upper most position.
Make sure the blower slide adjustment is not in the off position.
If used for an extended period of time, allow the blower to cool. The blower is thermally
protected and will shut off until cooled sufî‚¿ciently. It will resume normal operation when
cool.
IMPORTANT
Before you call for service, review this list. It may save you time and expense. The list includes common
occurrences that are not the result of defective workmanship or materials in this appliance.