Complete Owner's Guide

CAUTION
To avoid personal injury or property damage,
handle tempered glass shelves carefully. Shelves
may break suddenly if nicked, scratched, or
exposed to sudden temperature change. Allow
the glass shelves to stabilize to room temperature
before cleaning. Do not wash in dishwasher.
25
AUTOMATIC ICE MAKER - FREEZER (SELECT MODELS) STORAGE FEATURES

NOTE
Features may vary according to model.
Your refrigerator includes SpillSafe
TM
glass shelves
that are designed to catch and hold accidental spills.
You can easily adjust shelf positions in the fresh
food compartments to suit your needs. The
shelves have mounting brackets that attach to
slotted supports at the rear of each compartment.
Change the Position of a Shelf
1 Remove all food from shelf.
2 Lift the front edge up and pull the shelf out.
3 Replace by inserting the mounting bracket
hooks into the desired support slots.
4 Lower the shelf and lock into position.
IMPORTANT
Be aware of the air seal located at the rear of
the shelf. Shelves located on the left side should
have the air seal mounted on the far left side.
Shelves located on the right side should have
the air seal mounted on the far right side. This
is to ensure there is no interference with the
large air tower on the back wall of the cabinet.
This also applies to the crisper shelves.
Reposition the Air Seal
For slide-out shelves & crisper shelves:
1 Remove air seal by pushing down on the
ap with a downward rotation.
2 Position the air seal towards the outside
end of the shelf to avoid the air tower
when shelf is pushed back into place.
3 Install seal by sliding lower tab of seal up
into bottom rear slot of shelf with seal at a
downward angle then pulling up on seal ap
until seal sits snug on back of shelf and ap sits
at about a 10 degree angle from shelf surface.
For slide-under shelves:
1 Remove air seal by pushing seal straight back.
2 Position the air seal towards the outside
edge of the shelf to avoid the air tower
when shelf is pushed back into place.
3 Install seal by sliding the open channel end
of the seal onto back edge of shelf until seal
sits snug on back of shelf and ap sits at
about a 10 degree angle from shelf surface.
Flip Shelf
Slide-Under Shelf